ABB AV2123000 Positioner User Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
CALIBRATION
0.030
STEM IS
FLUSH
WITH BODY
0.030
STEM POSITION AT
BALANCE CONDITION
STEM POSITION TOP
ADJUSTMENT SCREW
STEM POSITION LOWER
ADJUSTMENT SCREW
T00777A
Figure 4-5. Pilot Valve Adjustment
3
2. Use a ⁄ 32 -inch Allen wrench (the wrench must be at least
5-inches long) to turn the lower adjustment screw clockwise the
same amount as the top adjustment screw to insure speed of
operation is the same in both directions (if desired). Be careful
when accessing the lower adjustment screw. Insert the Allen
wrench up through the bottom of the range spring (Fig. 4-6). This
adjustment controls the amount of air going to port 02.
NOTE: To adjust the pilot valve stroke to the factory setting, refer
to PILOT VALVE STROKE ADJUSTMENT in Section 8.
3. Test for satisfactory stroke time and adjust as required.
TOP ADJUSTMENT SCREW
SIGNAL
DIAPHRAGM
HINGE SPRING
LOWER ADJUSTMENT
SCREW
RANGE SPRING
ALLEN WRENCH
ACCESS
T00778A
Figure 4-6. Speed Adjustment Screws
GAIN AND SPEED ADJUSTMENTS
4 - 7