DTH TGK TGR - exhausto.de
DTH TGK TGR - exhausto.de
DTH TGK TGR - exhausto.de
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
3004346_2012_12_07.fm GB - Product information<br />
Fig. 7, 8 and 8a<br />
Step Action<br />
1 Make a hole in the roof approx. 30 mm larger than the roof duct.<br />
2 Loosen the overlying tile/roofing material and push it up to make room for the<br />
cover.<br />
PERFORM or lead cover Zinc cover<br />
NB<br />
It is a good i<strong>de</strong>a to bend the edge of flashing<br />
- applies to (at the bottom and, if appropriate, the visible<br />
PERFORM part of the si<strong>de</strong>s) to ensure greater strength<br />
only<br />
(better form stability) and a more attractive<br />
finish (fig. 8a.).<br />
3 Insert the roof duct carefully into the Insert the roof duct carefully into the roof<br />
roof so that the cover is flush with the so that the cover is flush with the roofing<br />
top of the tiles.<br />
material.<br />
4 Fit the support bars to the roof cap so Fit the support bars to the roof cap so that<br />
that the roof duct will be lifted approx. the roof duct will be lifted approx. 1 mm<br />
5 mm when the support bars are when the support bars are subsequently<br />
subsequently attached to the roofing attached to the roofing beams. This<br />
beams. This ensures that all the ensures that all the weight is borne by the<br />
weight is borne by the support bars. support bars.<br />
5 Roll out the cover material and knock<br />
it gently into shape with a rubber<br />
hammer or sandbag.<br />
6 Replace the overlying tile/roofing material on top of the cover.<br />
7 8<br />
45/64