Instruction manual 137350104 - Luna Norge AS

Height adjustment handle assemblySanding drumdust coverDust collection port elbowSanding drumdrive motorConveyorfeed motorConveyor belttrackingadjsuterStand mountingholeEvevation tensionadjustment screwsConveyor feedmotorExtensiontableSupport stand with easy movinghandle and wheelSanding drumnip guardVariablespeedcontrolboxExtensiontableFigure 1Elevation tensionadjustment screwsHeight adjustmentHeight adjustment crankhandle Figure 3ASSEMBLYAfter unpacking your WDS Wide Drum Sander and checking theLoose Parts List for missing components, you are ready to assembleand install the Height Adjustment Handle Assembly.1. Screw the Height Adjustment Handle into the threaded nut inthe Height Adjustment Crank using a slotted screwdriver untilsnug. (See Figure 5.)Height adjustment handleHeight adjustmentcrankThreaded nutOn/Off switchand variablespeed controlboxSanding drum motorFeedingconveyorFigure 2Figure 42. Locate the 4 mm set screw thresded into the side of the HeightAdjustment Crank. Position the Height Adjustment Crank overthe Height Adjustment Shaft with the set screw aligned with themachined flat area on the Height Adjustment Shaft.6 mmHex wrench4 mmHex wrench10/12 mmopen end wrenchHeight adjustment shaft(with machined flat)Figure 53. Lower the Height Adjustment Handle Assembly onto theHeight Adjustment Shaft and tighten the set screw with theWrench Key. (See Figure 6.)46