User Manual - Ruwido

User ManualProgramming the easytip Z3 in search modeNote:it is advised not to use search function before using the directcodes at the back of the manual.If the listed codes failed to operate the TV, VCR or SAT, orif the manufacturer was not included in the manual, thenthe search mode should be used. Search mode allows thecontroller to search and test every code in its memory.During search mode the remote is sending a signal to yourdevice every other second. If the unit finds a compatiblesignal it will power down the device into standby mode. Ifthis happens then test all the other functions of theremote. If some functions do not work correctly then itspossible your remote has found the first of manycompatible codes. At this point you should continue thesearch until a more compatible code is found. As there aremany codes for the controller to select and test, searchmode takes up to 15 minutes to perform.How to run the search mode (code 1111)Step 1 Switch on your TV, Sat, VCR (each unit must befully on with a broadcast picture on the screen orwith a running video tape in the video recorder).Step 2 Choose the device you want to control by turningthe adjusting ring until the printed ”TV”, ”VCR” or”SAT” is inline with the pointer on the housing ofyour remote.Step 3 Press and hold the (F) key until the LED flashestwice. (approx 2 seconds)Step 4 Within 5 seconds input the code 1111 (up, up, up,up). After you have input the code, wait for theLED to flash twice, this confirms that the numberyou selected has been installed into the unitcorrectly.Helpline 00800 31133113 7NL Gebruiksaanwijzing F Mode d’emploiI Istruzioni per l’uso D Bedienungsanleitung GB User Manual