Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
for lowering side<br />
Stop<br />
brush<br />
the side brush can be<br />
When<br />
too far the lowering stroke<br />
lowered<br />
be reduced by adjusting the<br />
can<br />
buffer.<br />
stop<br />
Stand sweeper on a flat surface<br />
<br />
Turn key switch to "0" and<br />
<br />
key<br />
remove<br />
Lower side brush<br />
<br />
Lowering ability of the side brush<br />
<br />
reduced in proportion to<br />
is<br />
Attach side trim panel<br />
<br />
Raise the side broom<br />
<br />
Stand sweeper on a flat surface<br />
<br />
Turn key switch to "0" and<br />
<br />
key<br />
remove<br />
Remove the swept material<br />
<br />
Remove tapes and string from<br />
<br />
sweep roller<br />
the<br />
Replacing it is necessary when<br />
—<br />
sweeping effect visibly<br />
the<br />
due to wear of the<br />
deteriorates<br />
bristles.<br />
Stand sweeper on a flat surface<br />
<br />
Raise the sweep roller<br />
<br />
Turn key switch to "0" and<br />
<br />
key<br />
remove<br />
Secure the machine against<br />
<br />
away using a wedge<br />
rolling<br />
Remove the debris container<br />
<br />
Unscrew screws of the rear<br />
<br />
panel on both sides of the<br />
closing<br />
Screw out fastening screw from<br />
<br />
sides of the main brush<br />
both<br />
Turn in M8x100 screws in<br />
<br />
holes as insertion aids<br />
fastening<br />
When mounting the new main<br />
<br />
make sure that the position<br />
brush<br />
Push the main brush on both<br />
<br />
of the fixtures<br />
sides<br />
Unscrew the M8x100 screws<br />
<br />
Fasten the main brush with the<br />
<br />
washers and the fastening<br />
flat<br />
screws<br />
Note:<br />
sure the flat washer is<br />
Make<br />
positioned; it must overlap<br />
properly<br />
main brush at the fixture on both<br />
the<br />
Insert rear closing panel and<br />
<br />
it with screws<br />
fasten<br />
Insert the swept material<br />
<br />
container<br />
Operating instructions <strong>KM</strong> <strong>90</strong>/<strong>45</strong> R English<br />
Check the sweep roller<br />
Replace the sweep roller<br />
Screw off left side panelling<br />
container<br />
from both sides of the unit<br />
Remove flat washer<br />
sides.<br />
Stop buffer<br />
unit<br />
Take out main brush<br />
upward screwing of the buffer.<br />
Remove closing panel<br />
of the bristle pile is right!<br />
29
Change language