FKS 2200 B1 - Lidl Service Website

Spare parts
The following spares are available from
Grizzly Service-Center (see P. 109 for the
address). Please indicate the machine type
and the number of the spare part with your
order.
Saw chain................................ 3009 1570
Chain bar................................. 3010 0420
Bio chain oil 1 liter ................... 3023 0001
Bio chain oil 5 liter ................... 3023 0002
If further spare parts should be necessary,
please find the part number on the exploded
drawings.
Technical Data
Electrical chainsaw ...........FKS 2200 B1
Rated input voltage..............230V~, 50 Hz
Input power................................... 2200 W
Safety class ....................................... / II
Chain speed ................................13,6 m/s
Weight
(without guide rail and chain)...........4,7 kg
Weight (with guide rail and chain) ...5,9 kg
Oiltank ............................................270 ml
Chain ............91P Oregon 3/8“ LoPro .050
...........Chrome cutting teeth, low-kickback
Chain bar.Oregon Typ OE, 160 SDEA041
Chain link separation......................10 mm
Chain width....................................1,3 mm
Teeth of the sprocket chain wheel ...........7
Length of the chain bar.................460 mm
Sawing length...............................395 mm
Acoustic pressure
level (LpA) ........96 dB (A); KpA=3,0 dB (A)
sound power level (LWA)
........................... 108 dB (A); KWA=3,0 dB (A)
Guaranteed sound power level ....112 dB (A)
Vibration (an)...........6,97 m/s 2 ; K=1,5 m/s 2
GB IE
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning:
The vibration emission value may
differ during actual use of the
power tool from the stated value
depending on the manner in which
the power tool is used.
Safety precautions aimed at protecting
the user should be based
on estimated exposure under
actual usage conditions (all parts
of the operating cycle are to be
considered, including, for example,
times during which the power tool
is turned off and times when the
tool is turned on but is running
idle).
Noise and vibration values were determined
according to the standards and
stipulations mentioned in the declaration
of conformity.
Technical and optical changes can be carried
out in the course of further development
without notice. All dimensions, references
and information of this instruction
manual are therefore without guarantee.
Legal claims, which are made on the basis
of the instruction manual, cannot thus
be considered as valid.
25