You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Operating Instructions <strong>KMR</strong> <strong>1700</strong> D English<br />
Take out the battery by the lifting<br />
loops<br />
When fitting the battery make<br />
sure that you first connect the<br />
positive post wire.<br />
Check that the battery poles and<br />
pole connectors are protected<br />
adequately with pole protecting<br />
grease<br />
Check and top up the<br />
battery acid level<br />
Danger!<br />
Always heed safety precautions for<br />
handling batteries!<br />
DieTake-off the 6 cell caps<br />
Draw a samble from each cell<br />
with the battery hydrometer<br />
Return each acid sample to the<br />
same cell<br />
At 20 °C, the acid of a fullycharged<br />
battery has a specific<br />
weight of 1,28 kg/l<br />
The acid of a partially-charged<br />
battery has a specific weight<br />
between 1,00 and 1,28 kg/l<br />
The specific gravity of the<br />
electrolyte must be the same in<br />
all cells<br />
Battery acid weight under 1,15 kg/l<br />
If the battery acid level is too low,<br />
top-up the cells with distilled<br />
water until the top edge of the<br />
plates is just covered with liquid<br />
Charge the battery until a specific<br />
weight of 1,28 kg/l is reached<br />
Charge the battery<br />
Danger!<br />
Always heed safety precautions<br />
for handling batteries!<br />
Charge the battery with the<br />
smallest possible charging<br />
current<br />
It is essential to observe the<br />
instructions provided by the<br />
manufacturerer of the charging<br />
unit<br />
Take-off all cell caps<br />
Connect the negative pole lead of<br />
the battery charger to the<br />
negative pole connection of the<br />
battery<br />
Connect the positive pole lead of<br />
the battery charger to the positive<br />
pole connection of the battery<br />
Switch on battery charger and<br />
insert mains plug<br />
Fault instructions<br />
The engine will not start or runs<br />
irregularly after starting<br />
— Sit on the driver seat<br />
— Charging or replacing battery<br />
— Fill up with fuel or ventilate fuel<br />
feed system<br />
— Replace fuel filter<br />
— Repair and clean the fuel feed<br />
line<br />
— Check the petrol line system,<br />
couplings and connections<br />
— Clean the air filter or replace the<br />
filter cartridge<br />
— Notify dealer<br />
The engine runs hot<br />
— Top up coolant<br />
— Purge the cooler<br />
— Tension V-belt<br />
— Notify dealer<br />
Sweeping machine is moving<br />
only slowly or not at all<br />
— Release parking brake<br />
— Clean the tyres or drive through a<br />
cleaning solution<br />
— Notify dealer<br />
Whistling noise in the hydraulic<br />
system<br />
— Top up hydraulic fluid<br />
— Notify dealer<br />
The brushes rotate only slowly or<br />
not at all<br />
— Notify dealer<br />
Little or no suction power in<br />
brush area<br />
— Clean filter<br />
— Notify dealer<br />
Machine making dust<br />
— Replace the sweep roller<br />
— Clean dust filter<br />
— Replace filter seals<br />
— Adjust or replace sealing strips<br />
— Notify dealer<br />
Sweeper unit does not pick up<br />
refuse<br />
— Empty the swept material<br />
container<br />
— Clean dust filter<br />
— Replace the sweep roller<br />
— Adjust the sweep mirror<br />
— Remove blocking of the main<br />
brush<br />
— Replace debris container –<br />
sealing strips<br />
— Adjust or replace sealing strips<br />
— Notify dealer<br />
Bin cannot be raised or lowered<br />
— Notify dealer<br />
Bin turns too slowly or not at all<br />
— Empty the swept material<br />
container<br />
— Notify dealer<br />
Problems with hydraulically<br />
actuated components<br />
— Notify dealer<br />
Performance data<br />
Sweeping performance<br />
data<br />
Theoretical area performance<br />
Without side brushes<br />
10750 m²/h<br />
With side brushes<br />
14000 m²/h<br />
Operating speed 0...10 km/h<br />
Driving speed 10 km/h<br />
Working widths<br />
Without side brushes<br />
1075 mm<br />
With side brushes<br />
1400 mm<br />
Gradability 11,5°/ 20 %<br />
Sweep container volume<br />
Total volume<br />
300 litres<br />
Usable volume<br />
130 litres<br />
Filter-/suction system<br />
Filter surface area 9 m²<br />
Intake volume 2200 m³/h<br />
Negative pressure 1500 Pa<br />
Automatic electric motor vibrator<br />
system<br />
47