KMR 1700 D - Kärcher

Operating Instructions KMR 1700 D English
Pull-out the oil dip rod
— The oil level must be between the
"Min" and the "Max" marks.
— Top up the engine oil if the oil
level is below the "Min" mark.
— Do not fill up beyond "Max"
Danger!
Danger of burns!
Let the engine cool-down
Release the cap screw of the oilfilling
opening
Fill-in engine oil
Oil types: See technical data
Close the oil fill opening
Wait at least 5 Min
Check the engine oil level
Replace engine oil and oil
filter
Engine oil replacement
Provide a collecting container for
at least 4 litres of oil
Screw-off the drain screw in the
anticlockwise direction
Danger!
Risk of burning if oil is hot
It is essential to fit a new gasket
when screwing-in the drain screw
again
Tighten drain plug with a torque
wrench to 25 Nm
Oil filter replacement
Screw-off the oil filter in the
anticlockwise direction
Clean the supporting and sealing
surfaces
Wet the gasket of the new oil
filter with oil before mounting
Hand-tighten new oil filter
Check the hydraulic oil
level
Open the rear engine covering
Check hydraulic oil level in the
top right inspection glass
Notes:
The hydraulic oil level must be
between the "Min" and "Max" marks.
See the chapter on replenishing
hydraulic oil if the hydraulic oil level
is below the "Min" mark.
Close the rear engine cover
Top-up with hydraulic oil
Release the driver’s seat and pull
it out downwards
Unscrew 4 screws at the
inspection cover
Unscrew oil filler hole cap
Warning!
Keep oil filler hole clean
36