KMR 1700 D - Kärcher

Operating Instructions KMR 1700 D English
Drive forwards and increase sweep
roller contact pressure
Note:
Only for "floating" operating mode
Open/close container
ejection tailgate
Warning!
To open or close the container
ejector flap grip it at its front
Open container ejection tailgate
Container ejection tailgate locked
Lift and close container ejection
tailgate
Adjust driver seat
Press the seat unlatching device
Displace the seat
Release the seat unlatching
device
Lock the seat by moving
backwards and forwards.
The seat is spring-loaded
The spring hardness can be
adjusted with the handwheel
Turn it clockwise:
The spring becomes firmer
Counterclockwise:
The spring becomes softer
Before every operation
General notes
Stand sweeper on a flat surface
Remove the ignition key
Lock the hand brake
Testing and maintenance
work
Check engine oil level and top-up
Check and overhaul the water
cooler
Check the sweep roller
Check the tyre air pressure
Refill fuel
Adjust driver seat
Clean-down the dust filter
See maintenance tasks chapter for
description
Commissioning
Start machine
Sit on the driver seat.
Driving pedals to neutral setting!
Lock the hand brake
Notes:
The machine is equipped with a
seat contact switch. The sweeper
switches off automatically as the
driver leaves his seat
Pull out the accelerator 1/3.
Preheating
Insert the ignition key in the
ignition switch and set to
position 1.
Preheating pilot lamp lit
Start engine
Turn ignition key to position 2
when preheating pilot lamp goes
out.
Release the ignition key when
the engine has started.
Run machine
Raise the sweep roller.
32