DW754.PM5 14-03-2001, 15:22 1 - Service

• Do not use the machine unless it is
properly mounted to the workbench and
all guards are in place.
• Always wear safety goggles when
grinding dry.
Switching on and off (fig. A)
• Switching on: set the on/off switch (1) to position 1.
• Switching off: set the on/off switch (1) to position 0.
Using the grinding wheel (fig. A)
• In order to achieve a straight cutting edge, move
it slowly backwards and forwards over the
grinding wheel (2). Only exert a light pressure.
Using the clamping and grinding attachment (fig. G)
• Insert the workpiece into the clamping bracket (26).
• Position the workpiece as required to obtain the
correct bevel angle. The angle is a function of the
protruding length X (see figure). For plane irons,
X should be approx. 20 mm, for chisels approx.
25 - 28 mm.
• Tighten the star knobs (27).
Using the honing wheel (fig. A)
• Move the workpiece slowly horizontally backwards
and forwards over the honing wheel (5). The tip of
the cutting edge of the workpiece should be in
contact with the wheel over a width of 0.5 to 1 mm.
Do not use any honing paste on the
honing wheel.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your DEWALT Power Tool has been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
• On a weekly basis, remove grindings from the
housing and the covers.
Lubrication
Your power tool requires no additional lubrication.
ENGLISH
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
Unwanted tools and the environment
Take your tool to an authorized DEWALT repair
agent where it will be disposed of in an
environmentally safe way.
• Take a worn grinding or honing wheel to your
dealer or a local recycling station where it will be
recycled or disposed of properly.
19 en - 6
DW754.PM5 27
14-03-2001, 15:23