28.07.2013 Views

Optica 661 FH - Thermex

Optica 661 FH - Thermex

Optica 661 FH - Thermex

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

M<br />

English<br />

Assembling the cooker hood:<br />

Separate the upper and lower parts of the inner telescopic frame. Remember the closed<br />

side must be placed parallel to the front of the cooker hood.<br />

Drill 4 holes ø8 into the ceiling and inserts 3 screws without tightening them fully<br />

(fig. 2 / see p. 45). Do not insert a screw into the hole marked X on the hole-template<br />

(screws and expansion bolts must suit the wall-type).<br />

Take the upper part of the frame, B, and place the 3 holes over the 3 screws, which are not<br />

yet fully-tightened (fig. 3 / see p. 46).<br />

Turn and adjust slightly to fit. Then screw the fourth screw, X, into place and tighten the<br />

remaining 3 screws so that the upper part of the frame, B, is completely fixed.<br />

Take the lower part of the telescopic frame, C, and place it into the upper frame, B. Adjust to<br />

the desired height and tighten into place with the accompanying 8 screws, G<br />

(fig. 4 / see p. 46).<br />

Extractor model:<br />

Fit the flexible tube into the prepared outtake hole (fig. 5 / see p. 47).<br />

Take the upper length of ducting and fasten with 4 screws, G (fig. 6 / see p. 47). The lower<br />

length of ducting should be allowed to hang on the outside but fixed temporarily with 2<br />

screws, G, so that the ducting does not fall down (fig. 7 / see p. 48). Insert the extractor into<br />

the frame and place 4 screws into the holes for mounting, N (fig. 8 / see p. 48).<br />

Attach the flexible tube, H, to the mounting flange (fig. 9 / see p. 49). Remove the 2 screws,<br />

G, and let the lowest length of ducting rest on top of the cooker hood (fig. 10 / see p. 49).<br />

27

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!