BA s_4 Universal, Innenteil, 105x210 mm CS6.indd - Ruwido

Operating the volume control on the TV or satellite receiver or the
DVB-T / cable box (STB) or DVD player / recorder
By default, the volume and mute controls are operated on the satellite receiver or
DVB-T / cable box or DVD player / recorder.
If you would like to operate these controls on the TV, please carry out the following
steps.
1) Press and hold the TV button (tv), until the signal LED ( ) fl ashes twice.
2) Enter the code 0 0 0 4 using the numeric buttons. The signal LED fl ashes twice
again.
If you would like to restore the volume control functions again to the satellite receiver
or the DVB-T / cable box (STB) or the DVD player / recorder, please carry out the
following steps.
1) Press and hold the TV button (tv) until the signal LED ( ) fl ashes twice.
2) Enter the code 0 0 0 5 using the numeric buttons. The signal LED fl ashes twice
again.
Disabling buttons
You have the option of disabling individual functions or features that are not required
on the s_4 remote control.
1) Press and hold the TV (tv), STB (stb), DVD (dvd) or AUX (aux) button, depending on
the function or feature that you would like to disable, until the signal LED ( )
fl ashes twice.
2) Enter the code 0 0 0 6 using the numeric buttons. The signal LED fl ashes twice
again.
3) Press all those buttons whose function or feature you would like to disable one
after another.
4) Press the level button used in step 1 to save the results.
Note :
The numeric and level buttons cannot be disabled.
Note :
If you would like to enable the buttons that you have disabled, please reset the remote
control completely. See function „Delete Settings (Reset)“
Code block
In order to prevent inadvertent programming of the s_4 remote control you can enable
the codes to be blocked.
1) Press and hold the TV button (tv) until the signal LED ( ) fl ashes twice.
2) Enter the code 0 0 0 7 using the numeric buttons. The signal LED fl ashes twice
again.
3) The remote control is now blocked against reprogramming
Note :
You can recognise that the code block is active (enabled) if the signal LED ( ) of the
s_4 remote control fl ashes long once and not twice briefl y when trying to programme
it.
Note :
Repeat the steps 1 to 3 if you wish to disable the code block once again.
Delete settings (Reset)
1) Press and hold the TV button (tv) until the signal LED ( ) fl ashes twice.
2) Using the numeric buttons, enter the code 0 0 0 0. The signal LED ( ) fl ashes
twice in order to confi rm that the s_4 remote control has been reset.
Note :
When you use the „Delete Settings (Reset)“ function, your s_4 remote control loses all
its programming and is restored to its condition at the time of delivery.
BA s_4 Universal, Innenteil, 105x210 mm CS6.indd 12 12.09.2012 12:51:06
12