Auping AVS Spiraalbodem

EN
10
5. Breakdowns
While an electrical fault may be a nuisance, it is never dangerous. All motors and
controls are fitted with all necessary safety devices and have double insulation.
The table below gives possible solutions to malfunctions.
If you have any doubts contact your dealer.
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Cause Search Solution
Caused by moving parts
touching each other.
The box spring is not
leveled because the floor
is not absolutely flat.
The reason for this may
be a missing part, or
parts that have not been
tightened properly or
have become loose when
the bed was moved.
The bed is not positioned
away from the wall.
There are unwanted
objects in the bed that
should not be there
(spoons, forks, pens,
etc.).
Apply Teflon spray. Do
not use oil.
Make sure the floor is
absolutely leveled.
Tighten parts.
Position the bed away
from the wall.
Remove those objects.
Important!
• A malfunctioning gas spring may cause the back section to come up utomatically
without remaining in a fixed position.
• Before consulting your dealer, please make sure that the operating cord and cord
guide can move freely and are not trapped between parts of the bed or mesh
base.
_0DV5G_5934 BW.pdf - pag.20 LET OP !!! Lage resolutie!
February 6, 2012