Plasmacluster Ion Generating Unit for Replacement - Sharp
Plasmacluster Ion Generating Unit for Replacement - Sharp Plasmacluster Ion Generating Unit for Replacement - Sharp
SPECIFICATIONS Model Power supply Fan speed Power consumption (W) Operating noise level (dBA) Airflow volume (m 3 /hour) Applicable floor surface area (m 2 )* 1 Ion density (ions/cm 3 )* 2 Power cord (m) Outer dimensions (mm) Weight (kg) IG-A20E IG-A40E 220-240V, 50/60Hz HIGH MED. LOW HIGH MED. LOW 22 14 9 39 20 10 45 40 34 47 40 34 468 390 306 840 648 510 23 50 25,000 12,000 7,000 25,000 12,000 7,000 2.0 594(W) 480(H) 230(D) 940(W) 480(H) 230(D) 10.5 15.0 ENGLISH *1 The target fl oor surface area for which an emitted airborne ion density of about 25,000 ions/cm 3 can be measured at a point near the center of the room (at a height of about 1.2m from the fl oor), during operation at the HIGH mode when the main unit is placed near a wall. *2 Ions, counted per cm 3 , blown into air near the center of the room (at a height of approx. 1.2m from the floor) during operation at each airstream setting when the main unit is placed near the wall. • The number of ions will vary according to the room conditions and operation mode. DEUTSCH FRANÇAIS Standby Power In order to operate the electrical circuits while the power plug is inserted in the wall outlet, this product consumes about 0.8W of standby power. For energy conservation, unplug the power cord when the unit is not in use. NEDERLANDS РУССКИЙ E-11
TROUBLESHOOTING Before calling for service, please review the TROUBLESHOOTING chart below. Since the problem may not be unit malfunction. Problem The Plasmacluster Ion Generator does not work. fl ashing faster (red) WHAT TO DO Make sure to put in the plug. Approx. 2 years and 2 month (Approx 19,000 hours) has been passed. Replace with a new Plasmacluster Ion Generating Unit. See page E-8,9,10. fl ashing (red) fl ashing (blue) fl ashing (blue) Plasmacluster Ions are not released. Press the Operation Button and restart. If all lights keep flashing, replace with new Plasmacluster Ion Generating Unit. See page E-8,9,10. • Dust may block the fi lter, clean the fi lter. Failure Unplug and ask the store you purchased or Sharp Sevice Center. fl ashing (blue) The discharged air has odor. A clicking or ticking sound comes from the unit while operating the Plasmacluster Ion Generator. The Plasmacluster Ion Generator releases a small trace of ozone which may produce odor. This is not detrimental to health. Loudness can be changed depending on a room humidity, but the effectiveness is the same. Relocate the Plasmacluster Ion Generator if necessary. Lighting (yellow) Filter cleaning time. See page E-7. After cleaning the filter, press FILTER RESET Button for 3 seconds. A discontinuous noise is heard. The air fl ow decreases. Filter is getting dirty. Clean the fi lter. After cleaning the filter, press FILTER RESET Button for 3 seconds. E-12
- Page 1 and 2: プラズマクラスターイオ
- Page 3 and 4: IMPORTANT SAFETY INSTRUCTIONS When
- Page 5 and 6: INSTALLATION POSITION Place the mai
- Page 7 and 8: OPERATION * This operation manual i
- Page 9 and 10: PLASMACLUSTER ION GENERATING UNIT R
- Page 11: HOW TO REPLACE THE PLASMACLUSTER IO
- Page 16 and 17: DEUTSCH INHALT WICHTIGE SICHERHEITS
- Page 18 and 19: TEILEBEZEICHNUNG Lüftungsgitter (L
- Page 20 and 21: AUFSTELLEN DES GERÄTES 1 Lösen Si
- Page 22 and 23: REINIGUNG UND PFLEGE WARNUNG: Wenn
- Page 24 and 25: SO TAUSCHEN SIE DIE PLASMACLUSTER-I
- Page 26 and 27: TECHNISCHE DATEN Modell Stromanschl
- Page 28: A. Entsorgungsinformationen für Be
- Page 31 and 32: INSTRUCTIONS IMPORTANTES RELATIVES
- Page 33 and 34: POSITION D’INSTALLATION Placez l
- Page 35 and 36: FONCTIONNEMENT * Ce manuel d’util
- Page 37 and 38: REMPLACEMENT DE L'UNITÉ GÉNÉRATR
- Page 39 and 40: COMMENT REMPLACER L’UNITÉ GÉNÉ
- Page 41 and 42: RÉSOLUTION DES PROBLÈMES Avant d
- Page 44 and 45: NEDERLAND INHOUD BELANGRIJKE VOORZO
- Page 46 and 47: BENAMING VAN DE ONDERDELEN Roosters
- Page 48 and 49: HOE DE UNIT INSTALLEREN 1 Schroef d
- Page 50 and 51: REINIGEN EN ONDERHOUD WAARSCHUWING:
- Page 52 and 53: HOE DE PLASMACLUSTER ION GENERATION
- Page 54 and 55: TECHNISCHE GEGEVENS Model Voeding V
- Page 56: A. Informatie over afvalverwijderin
- Page 59 and 60: ВАЖНЫЕ ИНСТРУКЦИИ
- Page 61 and 62: УСТАНОВКА Поместит
SPECIFICATIONS<br />
Model<br />
Power supply<br />
Fan speed<br />
Power consumption (W)<br />
Operating noise level (dBA)<br />
Airflow volume (m 3 /hour)<br />
Applicable floor surface area (m 2 )* 1<br />
<strong>Ion</strong> density (ions/cm 3 )* 2<br />
Power cord (m)<br />
Outer dimensions (mm)<br />
Weight (kg)<br />
IG-A20E<br />
IG-A40E<br />
220-240V, 50/60Hz<br />
HIGH MED. LOW HIGH MED. LOW<br />
22 14 9 39 20 10<br />
45 40 34 47 40 34<br />
468 390 306 840 648 510<br />
23 50<br />
25,000 12,000 7,000 25,000 12,000 7,000<br />
2.0<br />
594(W) 480(H) 230(D) 940(W) 480(H) 230(D)<br />
10.5 15.0<br />
ENGLISH<br />
*1 The target fl oor surface area <strong>for</strong> which an emitted airborne ion density of about 25,000<br />
ions/cm 3 can be measured at a point near the center of the room (at a height of about 1.2m<br />
from the fl oor), during operation at the HIGH mode when the main unit is placed near a<br />
wall.<br />
*2 <strong>Ion</strong>s, counted per cm 3 , blown into air near the center of the room (at a height of approx.<br />
1.2m from the floor) during operation at each airstream setting when the main unit is<br />
placed near the wall.<br />
• The number of ions will vary according to the room conditions and operation mode.<br />
DEUTSCH<br />
FRANÇAIS<br />
Standby Power<br />
In order to operate the electrical circuits while the power plug is inserted in the wall<br />
outlet, this product consumes about 0.8W of standby power.<br />
For energy conservation, unplug the power cord when the unit is not in use.<br />
NEDERLANDS<br />
РУССКИЙ<br />
E-11