2 - Boelens Machines BV

0 08/2005 Inhoud
3.10.5 Coördinatentransformaties definiëren .................................................................... 3-298
3.10.6 Cilindermanteltransformatie.................................................................................... 3-301
3.10.7 Zwenken..................................................................................................................3-304
3.10.8 Bijkomende functies................................................................................................ 3-309
3.11 G-Code invoegen in arbeidsstappenprogramma.................................................... 3-310
Programmeren met G-Code 4-313
4.1 G-Code-programma creëren .................................................................................. 4-314
4.2 G-Code-programma uitvoeren................................................................................ 4-317
4.3 G-Code-editor ......................................................................................................... 4-319
4.4 Rekenparameters ................................................................................................... 4-323
4.5 ISO-dialecten .......................................................................................................... 4-324
Simulatie 5-325
5.1 Algemeen................................................................................................................ 5-326
5.2 Programma in standaardsimulatie starten/annuleren............................................. 5-327
5.3 Afbeelding in bovenaanzicht................................................................................... 5-329
5.4 Afbeelding in het 3-vlakkenaanzicht ....................................................................... 5-330
5.5 Fragment vergroten ................................................................................................ 5-331
5.6 Driedimensionale weergave ................................................................................... 5-332
5.6.1 Positie van het fragment veranderen...................................................................... 5-333
5.6.2 Werkstuk doorsnijden ............................................................................................. 5-334
5.7 Snelweergave voor vormenbouw starten/annuleren .............................................. 5-335
5.8 Weergaven in snelaanzicht..................................................................................... 5-335
5.9 Werkstukgrafiek aanpassen en verschuiven.......................................................... 5-337
5.10 Afstandsmeting ....................................................................................................... 5-338
5.11 Zoekfunctie ............................................................................................................. 5-339
5.12 Delenprogrammablokken bewerken....................................................................... 5-340
5.12.1 G-blokken selecteren.............................................................................................. 5-340
5.12.2 G-Code-programma bewerken............................................................................... 5-341
Gegevensbeheer 6-343
6.1 Programma's beheren met ShopMill ...................................................................... 6-344
6.2 Programma's beheren met ShopMill op NCU (HMI Embedded)............................ 6-345
6.2.1 Programma openen ................................................................................................ 6-347
6.2.2 Programma uitvoeren ............................................................................................. 6-348
6.2.3 Meervoudige opspanning ....................................................................................... 6-348
6.2.4 G-Code-programma afwerken van USB-/netwerk-drive......................................... 6-351
6.2.5 Directory/Programma aanleggen............................................................................ 6-352
6.2.6 Meerdere programma's markeren .......................................................................... 6-353
© Siemens AG 2005 All rights reserved.
SINUMERIK 840D sl Bedienen/Programmeren ShopMill (BAS) - Uitgave 08/2005 xi
0