sostituzione ed equilibratura degli pneumatici fai-da-te - VAQ

More documents

Recommendations

Info

Remove the rim protectors and the C-clamp. Make sure there is still plenty of lube on it, as it will help the bead seat when inflating the tire. Install the valve core and cap. Then bounce the tire several times around the circumference. This helps to set the bead. Using a compressor with decent power. DO NOT HOLD THE TIRE NEAR THE RIM during this process. As the tire inflates it will POP onto the rim in a couple spots. If your fingers are in there you will not like the results. See the red arrow! I have had a few instances where the tire took as much as 4 bar of pressure to seat the bead. I wouldn’t generally go any higher than 3,5 bar, though I know a few who have gone as high as 5 bar. If the bead wont seat, and no air is staying in, you may have to use a ratcheting strap to compress the tire to get the bead to seat with air pressure. Just make sure you remove the strap as soon as it takes air in and holds a few pounds. The pressure on the strap will not only make it hard to get off, but might cause the strap to come off explosively. 18 of 23
My friend Chris made this stand for me, and I attached the beamerbalancer bearings to it. Place the beamerbalancer insert onto the wheel, ignore the rod for a moment. Install the adapter using wing nuts and nylon washers. Then add the rod through and put on the stepped sliders with black o-ring retainers, see above, and place it on the stand. 19 of 23
Page 1 and 2: SOSTITUZIONE ED EQUILIBRATURA DEGLI
Page 3 and 4: 2 tavole di legno per appoggiare il
Page 5 and 6: (F) Pulire il cerchio ora che è nu
Page 7 and 8: Abito in un paesello, ma i gommisti
Page 9 and 10: Ezio51 16 Novembre 2006 R1150RT 200
Page 11 and 12: Breaking the bead is made fairly ea
Page 13 and 14: With the upper bead off, you can li
Page 15 and 16: Check the rotation of the new tire.
Page 17: I have a couple of generic 9” lev
Page 21 and 22: Clean the top of the rim; opposite
Page 23: Next loosen the pinch bolt, but don

sostituzione ed equilibratura degli pneumatici fai-da-te - VAQ

Create successful ePaper yourself

Delete template?

Save as template?