GUIDE TCI LED DRIVERS 2016-17
VST BI Direct current electronic drivers Alimentatori elettronici in corrente continua Made in Europe professional led applications SELV RIPPLE FREE 5.1 Constant voltage LED drivers Alimentatori LED a tensione costante Rated Voltage Tensione Nominale 220 ÷ 240 V Frequency Frequenza 50...60 Hz AC Operation range Tensione di utilizzo AC 198 ÷ 264 V DC Operation range Tensione di utilizzo DC DC 176 ÷ 264 V (NO 150 W) Power Potenza 0 ÷ 150 W Maximum current output ripple Max. ondulazione della corrente uscita ≤ 3% (1) Reference Norms Norme di riferimento: EN 50172 (VDE 0108) EN 55015 EN 61000-3-2 EN 61000-3-3 EN 61347-1 EN 61347-2-13 EN 61547 VDE 0710-T14 Article Articolo Code Codice P out W V out DC I out DC ta °C tc °C l max. Power Factor h max. Efficiency (1) DC 50W 24V VST BI 122772 50 24 2 A max. -40...+45 70 0,97 > 90 DC 50W 12V VST BI 122776 50 12 4,2 A max. -40...+45 70 0,97 > 88 DC 50W 48V VST BI 122780 50 48 1 A max. -40...+45 70 0,97 > 90 DC 70W 24V VST BI (3) 122770 70 (3) 24 2,9 A max. -40...+45 70 0,97 > 91 DC 70W 12V VST BI 122778 70 12 5,8 A max. -40...+45 70 0,97 > 89 DC 70W 48V VST BI 122782 70 48 1,45 A max. -40...+45 70 0,97 > 91 DC 150W 24V VST BI 122774 150 24 6,25 A max. -40...+45 75 0,98 > 94 DC 150W 48V VST BI (2) 122784 150 48 3 A max. -40...+45 75 0,98 > 94 (1) Referred to V in = 230 V, 100% load - Riferito a V in = 230 V, carico 100% Accessories not supplied - Accessori non a corredo (2) Without KEMA - Senza KEMA Article - Articolo Code - Codice (3) Load allowed up to 75 W - Carico massimo 75 W dimmer SED 4.5A R57 (pag. 332) 120300 Features • AC/DC electronic driver with output in voltage, specific for installations in compliance with the standards of lighting applications. • Driver for built-in use. • It can be used for lighting equipment in protection class I. • Input and output terminal blocks on opposite sides. • Single terminal block on primary (terminal area 0,5 - 2,5 mm 2 / AWG20 - AWG13). • Double terminal blocks on secondary (wire cross-section up to 0,5 - 2,5 mm 2 / AWG20 - AWG13). • Protections: - against overheating and short circuits; - against mains voltage spikes; - against overloads. Caratteristiche • Alimentatore elettronico tipo AC/DC con uscita in tensione specifico per installazioni con Norme settore illuminazione. • Alimentatore da incorporare. • Utilizzabile per apparecchi di illuminazione in classe di protezione I. • Morsetti di entrata e uscita contrapposti. • Singola morsettiera su primario (sezione cavo fino a 0,5 - 2,5 mm 2 / AWG20 - AWG13). • Doppia morsettiera su secondario (sezione morsetto 0,5 - 2,5 mm 2 / AWG20 - AWG13). • Protezioni: - termica e cortocircuito; - contro le extra-tensioni di rete; - contro i sovraccarichi. 276 www.tci.it TCI professional LED applications
VST BI Direct current electronic drivers Alimentatori elettronici in corrente continua Made in Europe professional led applications Weight - Peso gr. 260 / 9,17 oz. Pcs - Pezzi 20 Weight - Peso gr. 300 / 10,58 oz. Pcs - Pezzi 20 60 2,36’’ DC 50W 24V VST-BI DC 50W 48V VST-BI DC 70W 24V VST-BI DC 70W 48V VST-BI 60 2,36’’ DC 50W 12V VST-BI DC 70W 12V VST-BI DC 150W 24V VST-BI DC 150W 48V VST-BI 178 7,00’’ 194 7,64’’ 36 1,42’’ 49 1,93’’ 190 7,48’’ 170 6,69’’ 206 8,11’’ 186 7,32’’ Wiring diagrams - Schemi di collegamento (Max. LED distance at page info8 - Massima distanza LED a pagina info8) V in N L OUT _ _ + + LED Example of application - Esempio di applicazione 5.1 V in N L VST _ _ OUT + + + R _ _ LV RGB G _ 350 B + R _ _ LV RGB G _ 350 B 1...6 LED 1...6 LED 1...6 LED 1...6 LED 1...6 LED 1...6 LED Constant voltage LED drivers Alimentatori LED a tensione costante TCI professional LED applications www.tci.it 277
- Page 260 and 261: SIRIO 150/300-1050 - 1...10 V & BIL
- Page 262 and 263: MAXI JOLLY US FP - FULL PROGRAMMABL
- Page 264 and 265: SIRIO 100/200-700 FP - FULL PROGRAM
- Page 266 and 267: SIRIO 150/200-700 FP - FULL PROGRAM
- Page 268 and 269: SIRIO 150/300-1050 FP - FULL PROGRA
- Page 270 and 271: POLARIS 150/200-700 FP - FULL PROGR
- Page 272 and 273: POLARIS 150/300-1050 FP - FULL PROG
- Page 274 and 275: DALI PROGRAMMER USB-DALI signal con
- Page 276 and 277: JOLLY AND MAXI JOLLY WITH CONFORMAL
- Page 278 and 279: 244 www.tci.it TCI professional LED
- Page 280 and 281: MIDNIGHT SERIES SERIE MIDNIGHT Made
- Page 282 and 283: MAXI JOLLY US MIDNIGHT Direct curre
- Page 284 and 285: BILEVEL SERIES SERIE BILEVEL Made i
- Page 286 and 287: JOLLY US BILEVEL Direct current dim
- Page 288 and 289: MAXI JOLLY US BILEVEL Direct curren
- Page 290 and 291: MAXI JOLLY HC BILEVEL BI profession
- Page 292 and 293: PLV SERIES (PUSH LOW VOLTAGE LED DR
- Page 294 and 295: MINIJOLLY HV PLV Direct current dim
- Page 296 and 297: MINIJOLLY LC PLV Direct current dim
- Page 298 and 299: JOLLY SLIM PLV Direct current dimma
- Page 300 and 301: MAXI JOLLY HC PLV BI professional l
- Page 302 and 303: CONSTANT VOLTAGE LED DRIVERS ALIMEN
- Page 304 and 305: UNTERPUTZDOSE professional led appl
- Page 306 and 307: EFU Direct current electronic drive
- Page 308 and 309: WU RGB IR & PUSH professional led a
- Page 312 and 313: VST professional led applications D
- Page 314 and 315: VST II professional led application
- Page 316 and 317: VSTR RGB - 1...10 V / PUSH / IR pro
- Page 318 and 319: DC 60W 24V DALI SLIM Direct current
- Page 320 and 321: DC 60W 24V SLIM Direct current elec
- Page 322 and 323: professional led applications Made
- Page 324 and 325: DCC/U S IP54 IP54 direct current el
- Page 326 and 327: STCP/U IP54 IP54 resin-bonded direc
- Page 328 and 329: SLIM/U IP65 professional led applic
- Page 330 and 331: ST2 IP67 professional led applicati
- Page 332 and 333: professional led applications Made
- Page 334 and 335: LV HR Direct current electronic dri
- Page 336 and 337: LV RGB 250 / 350 / 500 Direct curre
- Page 338 and 339: LV RGB IR Direct current electronic
- Page 340 and 341: professional led applications Made
- Page 342 and 343: COMBO LED Dimmable electronic drive
- Page 344 and 345: ELDN T Emergency light KIT for powe
- Page 346 and 347: ELED HP Emergency light KIT for pow
- Page 348 and 349: BATTERY KIT Battery KIT for ELDN T
- Page 350 and 351: ELBT Emergency light KIT for 12 Vdc
- Page 352 and 353: ELHT Emergency light KIT for 230 Vd
- Page 354 and 355: professional led applications Made
- Page 356 and 357: MW 70 LED DIMMABLE Dimmable (TRAILI
- Page 358 and 359: W 105 LED PWM Dimmable 12 V electro
VST BI<br />
Direct current electronic drivers<br />
Alimentatori elettronici in corrente continua<br />
Made in Europe<br />
professional led applications<br />
Weight - Peso gr. 260 / 9,<strong>17</strong> oz.<br />
Pcs - Pezzi 20<br />
Weight - Peso gr. 300 / 10,58 oz.<br />
Pcs - Pezzi 20<br />
60<br />
2,36’’<br />
DC 50W 24V VST-BI<br />
DC 50W 48V VST-BI<br />
DC 70W 24V VST-BI<br />
DC 70W 48V VST-BI<br />
60<br />
2,36’’<br />
DC 50W 12V VST-BI<br />
DC 70W 12V VST-BI<br />
DC 150W 24V VST-BI<br />
DC 150W 48V VST-BI<br />
<strong>17</strong>8<br />
7,00’’<br />
194<br />
7,64’’<br />
36<br />
1,42’’<br />
49<br />
1,93’’<br />
190<br />
7,48’’<br />
<strong>17</strong>0<br />
6,69’’<br />
206<br />
8,11’’<br />
186<br />
7,32’’<br />
Wiring diagrams - Schemi di collegamento (Max. <strong>LED</strong> distance at page info8 - Massima distanza <strong>LED</strong> a pagina info8)<br />
V in<br />
N<br />
L<br />
OUT<br />
_<br />
_<br />
+<br />
+<br />
<strong>LED</strong><br />
Example of application - Esempio di applicazione<br />
5.1<br />
V in<br />
N<br />
L<br />
VST<br />
_<br />
_<br />
OUT<br />
+<br />
+<br />
+ R<br />
_<br />
_ LV RGB G<br />
_ 350<br />
B<br />
+ R<br />
_<br />
_ LV RGB G<br />
_ 350<br />
B<br />
1...6 <strong>LED</strong><br />
1...6 <strong>LED</strong><br />
1...6 <strong>LED</strong><br />
1...6 <strong>LED</strong><br />
1...6 <strong>LED</strong><br />
1...6 <strong>LED</strong><br />
Constant voltage <strong>LED</strong> drivers<br />
Alimentatori <strong>LED</strong> a tensione costante<br />
<strong>TCI</strong> professional <strong>LED</strong> applications www.tci.it<br />
277