PLANETARI - Klindex.info

INSTRUCTION FOR GRINDING GRANITEPLANETARIO K2000 is the most suitable Planetario for grinding granite floors. Using K2000, thediamond-disks run at about 2000 rpm. The high speed is very important to polish granite: only by cuttingat high speeds is it possible to smooth granite thoroughly without leaving scratches and to obtain anexcellent shine.GS1: Start with metallic-diamond-disc GS1 and work until the floor is perfectly evened without anylippages. This stage is the most important stage. It is absolutely important to eliminate all the roughedges. If floors are not perfectly evened, you will not obtain a good shine. We suggest to move themachine with a movement “forward and backward” and at the same time “to right and left” following thelines of the tiles. With GS1 don’t work up to the wall but stay 10 cm (25 inch) far. After any step removethe mud by vacuum cleaner and not by hand.GS2: After levelling, proceed with GS2. It is ideal to grind the floors in a cross-patterned direction.GS3: Proceed with metallic-diamond-disc GS3. It is ideal to grind the floors in a cross-patterned direction.No scratches should be visible on the floors after this step.NOTE 1 : it is suggested to add EXTRA WEIGHT according to the hardness of the floor and the toolsgrip.NOTE 2 : it is suggested to use AKTIVATOR 1 for sharpening the metallic diamond toolsAfter GS3 proceed in one of the following system:a) FOR HARD AND COMPACT GRANITE : proceed with G4, G5; G6, G7 and if it is necessarywith G8b) FOR OPEN AND POUROS GRANITE :1) after GS3 proceed with PAVELUX G3, G4 and G5. PAVELUX are magnesian abrasive useful toclose the microporosity of the granite2) after PAVELUX G5 you can proceed with PAVELUX G6, G7 and G8 or with diamond discs GK6,GK7 and GK8After grinding, proceed to shine the floors using our POLISH POWDER:POLISH KG: for dark-coloured granitePOLISH KG CLEAR: for light-coloured graniteTo use the POLISH: spread the powder on the floor and add a bit of water. Using the DISCOLUX orSTEEL WOOL, make the cream like a “yogourt” consistency and work until the desired shine is achieved.If necessary, add another little bit of Polish and water. .PLEASE NOTE: For polishing granite floors it is important to work with the THERMIC DISC becausePOLISH KG works only when the floor is warmed. IT IS IMPORTANT TO APPLY THE POLISHPROGRESSIVELY OVER SMALL AREAS 1m 2 x 1m 2 .STEEL WOOL: when the floor is dry, polish with steel wool.NYLON BRUSH: wash accurately the floor with a nylon brush. :BRILLUX: when the floor is perfectly dry spray a little bit of BRILLUX and polish with RED PAD orWHITE PAD.KORREKTOR: to obtain a deep shine, spread KORREKTOR on the floor by cloth , wait until becomesperfectly dry and polish with DISCOLUX. KORREKTOR is also a good waterproofing..KI WATERPROOFING: for a special water-proofing it is suggested to apply KI WATERPROOFING.After polishing, proceed to enhance the shine with GRANITOLUX or BRILLUX:The granite will look like it was factory-made!Data ultimo aggiornamento: 26/11/2009 Pag. 6 di 28