PLANETARI - Klindex.info

INSTRUCTIONS FOR GRINDING MARBLEGRINDING ROUGH OR UNEVEN MARBLE FLOORS1) To start, use metallic diamond discs MS1 until the surface is even. PLEASE NOTE: If the floors arenotably uneven, start the grinding process with MS0 and proceed with MS1. For a faster and moreefficient job we advise you to work with a slow and constant movement, proceeding in a linear patternfollowing the lines of the tiles. Between one stage and another always remove the mud with a vacuumcleaner. With MS1 or MS0 don’t work up to the wall but stay 10 cm (25 inches) far.2) When the floor has been perfectly evened and there are not any lippages proceed with the metallicdiamond disc MS2, being careful not to leave any untreated areas (we emphasize the importance ofworking in linear patterns). With MS2 don’t work up to the wall but stay 5 cm (25 inches) far. Beforestarting any new work do not forget to use AKTIVATOR 1 for sharpening the metallic diamondtools.3) Proceed with the resin diamond disc M3 – M4 – M5 using the same procedure used with MS2.4) Working on green, black marble floor hard to polish, proceed with the diamond disc M6 and/or M7(smaller grain)5) After grinding, proceed to shine the floors using our POLISH POWDER:the Company has developed and produces a complete range of Polish to shine all kinds of marble floors:─ POLISH KP 85 the most used for almost all kind of marble.─ POLISH KP 92 the best for calcareous marble.─ POLISH PALLADIANA for terrazzo, palladiane and conglomerate.─ POLISH COLOR for green, black or marble that contains iron pigments.─ POLISH KMT for soft marbles like Carrara─ POLISH GREY the special polish for non-calcareous marble.To use the POLISH: spread the powder on the floor and add a bit of water. Using the DISCOLUX, makethe cream like a “yogourt “ consistency and work until the desired shine is achieved.If necessary, add another little bit of Polish and water.6) When the desired shine is achieved, wash the floor with DISCOLUX. When the floor is dry, polishwith a DRY white disc.NOTE 1: Do not leave the POLISH cream on the floor for over 30 minutes without washing. The excesspowder remaining on the floor surface may ruin the shine.NOTE 2: Usually the POLISH is used with DISCOLUX. Only when using POLISH COLOR should steelwool be used.NOTE 3: THERMIC PLATE WARMER: Using the THERMIC DISC instead of the NORMAL PADHOLDER the work will be faster and the shine deeper.RESTORING and MAINTENANCE1) If the floor doesn’t have lippages but only scratches, you may start with the M4 and proceed with theM5 diamond discs. If the scratches are very deep you may start with the M3 disc.2) If the floor has lippages or is uneven use diamond discs series JUMPER and/or KLIMBER. They havespecial bevel that allows to jump on lippages without breaking.Data ultimo aggiornamento: 26/11/2009 Pag. 5 di 28