Model 5980 - Sioux Tools

Model 5980Form # Z656Date 3-011AIncludes - Foreseen Use, Work Stations, Putting Into Service,Operating, Dismantling, Assembly and Safety Rules.Manufacturer/SupplierSioux Tools lnc.2901 Floyd BoulevardP.O. Box 507Sioux City, IA 51 102U.S.A.Tel No. 71 2-252-0525 Fax No. 71 2-252-4267Product Net Weight Recommended Use Of0.48 Ibs Balancer Or Support0.22 Kg NOAir PressureImportantRead these Instructions carefully before installing, operating,servicing or remiring this tool. Keep these instructions in a safeaccessible place. -BPMProduct Type13,000Air Engraving PenModel NolNosIRecommended Hose BoreICycles Per Min. ISerial No.Recommended Max.Size - Minimum 1 Hose Length114 Ins 8 M/M 1 30 Ft 10 MNoise Level: Sound Pressure Level 78.0 dB(A)Sound Power Level 90.0 dB(A)Recommended Working 6.2 bar 90 PSIMaximum 6.2 bar 90 PSIPersonal Safety EquipmentBeforeUse - Safety Glasses YES 1Atways Read InstructionsUsing Power ToolsAlways Wear SafetyUse - Safety Gloves YES GogglesUse - Safety BootsUse - Breathing MasksUse - Ear Protectors YES A ;zztEgedSafety rules when using a 5980 -Air Engraving Pen- Prolonged exposure to vibration may cause injury.-Read all instructions before using this tool. Alloperators must be fully trained in its use and aware ofthese safety rules.- Do not exceed the maximum working air pressure.- Use personal protection equipment as recommended.-Use only compressed air at the recommendedconditions.-If the tool appears to malfunction, remove from useimmediately and arrange for service and repair. If it isnot practical to remove tool from service, then shut offthe air supply to the tool and write orhave written a warning note andTest Method: Tested in accordance with Pneuroptest code PN8NTC1 and IS0 Standard 3744Vibration Levelattach it to .- the . tool. .~ Take Air From Top- If tool is to be used with a balancer orshou,d Be or Laqeother suspension device, ensure thatthe tool is firmly attached to thewith Sufficient Capacitysuspension/support device.TO Maintain Recommended-When operating the tool, always keep Working Pressure AIthe body and particularly the handsOperate Shut Off ValLess than 2.0 Meters / Sec2Test Method: Tested in accordance with IS0standards 8662 Part 1-Always when using the tool, adopt a firm footing and/orposition and grip the tool sufficiently only to overcomeany reaction forces that may result from the tool doingwork. Do not overgrip.-Use only correct spare parts for maintenance andrepair. Do not improvise or make temporary repairs.Major servicing and repairs should only be carried outby persons trained to do so.-Do not lock. tape. wire. etc. the 'On/Off9 valve in 'On'position.-Always shut off the air supply to the tool and open theair regulator to exhaust the air from the feed hosebefore fitting, removing or adjusting the workingattachment fitted to the tool.- Before using the tool, make sure that a shut off deviceaway from the working attachmentfixed to the tool.-The tool is not electrically insulated.Never use the tool if there is anychance of coming into contact withlive electricity. Recommended Air Supply System Figure 1Some dust created by powersanding, sawing, grinding, drilling,and other conshucfi'on activities contains chemicals known tocause cancer, birth defects or other reproductive harm.Page No 1