Talis S² 32040000 / 32041000 32048000 Talis S² ... - Hemfint.se

English66Safety Notes66Gloves should be worn during installation to preventcrushing and cutting injuries.66The shower system may only be used for bathing,hygienic and body cleansing purposes.66The hot and cold supplies must be of equalpressures.Installation Instructions• The fitting must be installed, flushed and tested afterthe valid norms.• Prior to installation, inspect the product for transportdamages.After it has been installed, no transport orsurface damage will be honoured.• If the instantaneous water heater causes problems orif you wish to increase the water flow, the EcoSmart ®(flow limiter) located behind the aerator can beremoved.Technical DataThis mixer series-produced with EcoSmart ® (flowlimiter)Operating pressure:max. 1 MPaRecommended operating pressure: 0,1 – 0,5 MPaTest pressure:1,6 MPa(1 MPa = 10 bar = 147 PSI)Hot water temperature: max. 80°CRecommended hot water temp.: 65°CHansgrohe mixers can be used together withhydraulically and thermically controlled continuous flowheaters if the flow pressure is at least 0,15 MPa.The product is exclusively designed for drinking water!Symbol descriptionTo adjust the hot water limiter on single levermixers, please see page 38. No adjustmentis necessary when using a continuous flowwater heater.Do not use silicone containing acetic acid!Dimensions (see page 34)Flow diagram(see page 35) with EcoSmart ® without EcoSmart ®Spare parts (see page 36)Special accessoriesspecial tool 58085000 (order as an extra)Installation putty (order as an extra)seal 98996000 (order as an extra)Operation (see page 39)Hansgrohe recommends not to use asdrinking water the first half liter of waterdrawn in the morning or after a prolongedperiod of non-use.Cleaningsee enclosed brochureTest certificate (see page 40)4Assembly see page 31