gb use and maintenance manual blast chiller/shock freezer

1.3 CONNECTION1.3.1 CONNECTION TO EL.MAINS MODELS BC/BF051, BC/BF101, BF051TBefore making the connection to the mains, ensure that the voltage and frequency are as indicated on theappliance nameplate. A variation of +/-10% on the rated voltage is permitted.CAUTION: NEVER USE SOCKETS OR PLUGS WITHOUT EARTH CONNECTION THE MAINS SOCKET(16A/250 VOLTS) MUST HAVE AN EARTH CONNECTION.To protect the appliance against overloads or short-circuits, it must be connected to the mains by meansof a suitably rated high sensitivity (30 mA) differential security breaker with manual reset.When calculating the rating of this protective device, consider that:Imax = 2,3 In (rated current)Icc (short-circuit current)= 4500A.1.3.2 CONNECTION TO EL.MAINS MODELS BC/BF151Before connection to mains make sure that voltage and frequency of mains equal 400/3/50.A tollerance of +/- 10% is admissible.CONNECT THE APPLIANCE TO AN OUTLET WITH A FOUR-POLE SWITCH AND INTEGRAL THERMALOVERLOAD CUT-OUT.When calculating the rating of this protective device, consider that:Imax = 2,3 In (rated current)Icc (short-circuit current) = 6000A.1.4 REINSTALLATIONIn case of reinstallation, proceed as follows:1) Switch off the mains switch;2) Disconnect the plug from the power supply socket and rewind the cable;3) Remove all foods from the refrigerator and clean the inside and the accessories thoroughly;4) Repackage the appliance, taking care to fit the polystyrene guards in their original positions and secure thewooden base, to prevent damage in transit;5) For the new positioning and connections, proceed as previously described (INSTALLATION PROCEDURES).5