caution - Tekno Point

♦ CONNECTION OF SIGNAL LINE OF WIRE CONTROLLER(1) Open the cover of the electric box of the indoor unit.(2) Pull the signal cable of the wire controller through the rubber ring.(3) Plug the signal line of the wire controller onto the 4-bit pin socket at the circuit board of the indoor unit.(4) Use cable fastener to bundle and fix the signal cable of the wire controller.◊ Wires specificationsModels of Power connecting cable Indoor-outdoor connecting cableindoor units Section Section3500 W 1.5 mm² x 3 1.5 mm² x 45300 W 1.5 mm² x 3 1.5 mm² x 47100 W 2.5 mm² x 3 2.5 mm² x 4◊ Electrical wiringMain power supplyTo outdoor unit1 x 2 DC INVERTER1 x 3 DC INVERTERPOWERLBOUTDOOR UNITAOUTDOOR UNITINDO O R AXT1INDO O R B XT1 INDO O R C XT1NLINDOOR UNITSBAINDOOR UNITS A B C1 x 4 DC INVERTEROUTDOOR UNITINDOOR AXT1INDOOR B XT1 INDOOR C XT1 INDOOR D XT1INDOOR UNITS A B C D1 x 5 DC INVERTEROUTDOOR UNITL N N(1) 2 3N(1) 2 3N(1) 2 3N(1) 2 3N(1) 2 3POWER / ALIMENTAZIONEN(1) 2 3N(1) 2 3 N(1) 2 3N(1) 2 3N(1) 2 3INDOOR UNITSINDOOR UNIT A INDOOR UNIT B INDOOR UNIT C INDOOR UNIT D INDOOR UNIT E59