caution - Tekno Point

♦ INSTALLATION OF WIRED CONTROLLER◊ Installation location of wired controller1. Never install wired controller at wet place or under sunlight directly.2. Never install the unit and wired controller at the place where there is electromagnetic interference.3. Make sure communication line is connected into correct port to avoid communication malfunction.◊ Installation of wired controllerNo. DescriptionSocket’s base box installed in the wallSoleplate of controllerScrew M4X25Front panel of controllerScrew ST2.2X6.5Pay attention to the following items during installation of wired controller:1. Cut off power supply of heavy-current wire embedded in mounting hole in the wall before installation. It is prohibitedto perform the whole procedure with electricity.2. Pull out 4-core twisted pair line in mounting hole and then make it through the rectangle hole at the back ofcontroller’s soleplate.3. Joint the controller’s soleplate on wall face and then fix it in mounting hole with screws M4X25.4. At last, insert the 4-core twisted pair through rectangle hole into controller’s slot and buckle the front panel andsoleplate of controller together.Caution:1. To ensure normal communication of unit, signal line and wiring (communication) of wired controller should separatefrom power cord and indoor/outdoor connection lines. The distance between them should be kept 20cm in min.◊ Connecting cable between indoor PCB and wire controller45