caution - Tekno Point

● TIMER SETTINGUnder OFF/ON state of the unit, push the button Timer to set TIMER ON/OFF, each time you press the button ▲(▼)thetime increases (decreases) by 0.5 hours. Press the button Enter/Cancel if you want to confirm/cancel the TIMERON/OFF setting.Turn on the unit,without setting timerfunctionPress «Timer»button to set thetimer functionPress «▲or▼» to adjusttimePress «Enter/cancel»button to finish timersettingPress «Timer»button to canceltimer setting● SWING SETTING- Push the Function button for the first time when operation, it will start the swing function. Push the Enter/Cancel buttonto make a confirmation.- When swing function is on, press the Function button to enter the Swing setting interface, after that press Enter/cancelto cancel this function.Turn on the unit,without turning onswing functionPress «Function»button into swingstatePress «Enter/cancel»button to confirmPress «Function»button into swingstatePress «Enter/cancel»button to cancel swingfunctionNote:1) Sleep, Save, Turbo, Blow or Quiet setting is the same as the Swing setting.2) After the setting has been done, it has to press the key “Enter/cancel” to back to the setting status or quitautomatically five seconds later.● SLEEP SETTINGSLEEP mode can be set in COOLING or HEATING operation mode. This function gives you a more comfortableenvironment for sleep.In SLEEP mode,- Fan speed is automatically set at low speed.- Press the "SLEEP" button to set the unit to the sleep mode. The SLEEP indicator will light up on the display. Thetemperature increases/decrease in cooling/heating mode operation by 1°C at set intervals. After reaching 2°C the unitmaintains this temperature through to the eighth hour (8 hours) of operation in the "SLEEP" mode and then switches offautomatically.Turn on the unit,without turning on sleep modePress «Function»button into sleep statePress «▲ or ▼»switch modesPress «Enter/Cancel» to setsleep modePress «Function»button into sleep statePress «Function»button into sleepstate● TURBO SETTINGTurbo function: The unit at the high fan speed can realize quick cooling or heating so that the room temperature canquickly approach the setting value.In the Cooling or Heating mode, press Function till the unit enters the Turbo setting interface and then pressEnter/Cancel to confirm the setting.When the Turbo function is activated, press Function to enter the Turbo setting interface and then press Enter/Cancel tocancel this function.Notes:1) When the Turbo function is activated, if the difference between the room temperature and set temperature is at orbelow 2°C (detected in successive 1 min.), the Turbo function will be automatically deactivated.2) Turbo function is unavailable in the Dry and Fan mode. And the Turbo function is off after power failure and thenpower recovery. If Quiet function is on, Turbo function will be canceled subsequently.● SAVE SETTINGSave: Energy saving which will result the air conditioner runs in smaller temperature range is realized by setting lowerlimited value in the Cooling or Dry mode and upper limited value in the Heating mode.Save Setting for Cooling:Under the “On” state and in the Cooling or Dry mode of the unit, press Function to enter the Save setting interface andthen press ▲ or▼ to adjust the lower limited value in the cooling mode. After that, press Enter/Cancel to activate theSave function. The initial lower limited value in the Cooling mode is 26°C.When the Save function is activated, press Function to enter the Save setting interface and then press Enter/cancel tocancel this function.42