MODEL 2604 CONTROLLER - USER GUIDE - d a n m a r k

Programmer Operation2604 ControllerTable Number:4.7.2dThese parameters are associated withPSP3 and only appear if PSP3 isconfiguredPROGRAM RUN(PSP3 Page)Parameter Name Parameter Description Value Default AccessLevelSeg Time Rem Segment time remaining h: m: sPSP3 TypePSP3 WSPPSP3 TargetPSP3 Dwell TmPSP3 RatePSP3 HBk ApplRunning segment type forprofiled setpoint 3Working setpoint for profiledsetpoint 3 1Running segment target forprofiled setpoint 3 1Time remaining in runningsegment for profiled SP 3Running segment rate forprofiled setpoint 3 1Holdback applied for profiledsetpoint 3StepDwellRampDisplayrangeDisplayrangeDisplayrangeDisplayrangeNoYesL1. ReadOnly shownin RampRate prog.L1. Alterablein HoldL1. Alterablein HoldL1. Alterablein HoldL1. Not inTime ToTarget progL1. Readonly shownif configured1Range limited by user defined upper and lower limitsNote:The above table shows a complete list of all possible parameters. If a feature is not configuredparameters associated with that feature will not show.4.8. TO CREATE OR EDIT A PROGRAM• A running program cannot be edited, it must be put into Reset mode.• Changes can be made to remaining segments of a running program but these are‘temporary’ changes which apply only to the current run. These changes will not apply tosubsequent runs.• Other programs can be created or edited when another program is running.To create or edit a program it is first necessary to define the effect that various parameters willhave on the overall program. These parameters will be found under the page headerPROGRAM EDIT (Program Page), see section 4.8.1. and 4.8.2.When these parameters have been defined then set up the parameters which define eachindividual segment. These parameters will be found under the page header PROGRAMEDIT (Segments Page), see section 4.8.3. and 4.8.4.4-14 User Guide Part No HA026491 Issue 3.0 Apr-02