Benutzerhandbuch - Online USV Systeme

O P E R A T I O NFrequencyConverterOverload AlarmLevelTransfer to BypassWhen OverloadPower StrategyAutomatic StartDelayAutomatic on BatteryShutdownStart on Battery"Enabled", "Disabled"In the "Enabled" mode, the UPS system functionsas converter. The bypass mode andall bypass-related warning messages aredisabled.Recommendation: Do not change.10%, 20%, 30%, ... 100%These values only affect the warning messagethreshold, not the UPS mode such as switchingmodes or shutting downRecommendation: Do not change."Immediate", "After Delay"In the "Immediate" mode, the device willswitch the mode for a load of >102%.In the " After Delay " mode, the switch occursaccording to the technical data.Recommendation: Do not change."Normal", "High Efficiency"See Setting the power strategyRecommendation: Do not change."Disabled", "No Delay",1s, 2s, … 32767sIn the "Disabled" mode, the automatic restart isnot allowed. (see Configuring load segments)Recommendation: Adapt to requirements."Disabled", "No delay",1s, 2s, … 32767sThe shutdown is aborted, if the mains poweris restored before expiration of the waitingtime. (see Configuring load segments)Recommendation: Adapt to requirements."Enabled", "Disabled"A minimum battery voltage must be presentso that the UPS system starts.NOTE: During commissioning, the UPS systemmust be connected to the mains powerand input voltage must be present.Recommendation: Do not change."Disabled"100%"Immediate""Normal"Segment 1"No Delay"Segment 2"No Delay"Segment 1"Disabled"Segment 2"Disabled""Enabled"99 / 222XS700-XS3000_manual_ger_eng_it_V1.1.0.doc ........................................................... R. Kistler