Benutzerhandbuch - Online USV Systeme

O P E R A T I O NEnergy SavingModeRemote ShutdownDelayDelayed ShutdownDelayOn Battery NoticeDelaySite Wiring FaultAlarmBypass VoltageLow LimitBypass VoltageHigh LimitQualify BypassSynchronizationWindowUnsynchronizedTransfers"Disabled", 50W, 100W, ... 1000WThe output of the UPS system is shutdown ifthe UPS system is running in battery modeand the output power lies below the selectedthreshold value.Recommendation: Do not change."No Delay", 1s, 2s, ... 10800sRecommendation: Do not change."No Delay", 1s, 2s, ... 10800sOnly active via signal inputRecommendation: Do not change.0, 1s, 2s, ... 99sRecommendation: Do not change."Enabled", "Disabled"An active wiring fault warning message(on the line input) prevents the starting ofthe UPS system or forces the battery mode, ifthe UPS system is in operation. Bypass modeis disabled.Special case IT system (Fr. Isolé Terre): E.G.in hospitals, ships and trains, change it to"Disabled." Otherwise does not start up UPS.Recommendation: Change only in specialcases.-4%, -5% ... -20% of the nominal voltageSee Configuring the bypass settingsRecommendation: Do not change.+4%, +5% ... +20% of the nominal voltageSee Configuring the bypass settingsRecommendation: Do not change."Never", "Always on UPS fault", "Always","When in Spec"See Configuring the bypass settingsRecommendation: Do not change."Sync disabled",± 0.5Hz, ± 1.0Hz, ± 2.0Hz, ± 3.0Hz]See Configuring the bypass settingsRecommendation: Do not change."Enabled", "Disabled"See Configuring the bypass settingsRecommendation: Do not change."Disabled""No Delay"120s5s"Enabled"-15% of thenominal voltage+10% of thenominal voltage"When inSpec"± 3.0Hz"Disabled"100 / 222XS700-XS3000_manual_ger_eng_it_V1.1.0.doc ........................................................... R. Kistler