A/C Components - Stixe

Installation InstructionsGBPrecautions for Compressor removal1. To reclaim refrigerant from the A/C unit, use certified recoveryequipment.2. When handling refrigerant, follow the governmental regulations.3. To remove the Compressor, refer to the appropriate vehicle repairmanual.4. In order to keep moisture out of the system, cap the open fittingsimmediately when disconnecting hoses.5. Always replace receiver/drier.Compressor oil inspection procedureBefore installing the new Compressor, check the amount of Compressoroil necessary for the system. Follow the procedure described below;ExampleA - B =Oil amount to remove from new CompressorA (new Compressor)B (remaining in old Compressor)Oil amount to remove from newCompressorCompressor oil id chartCompressorType10pa, 7sb, 6se,Sc, 6ca seriesTv seriesRefrigerantTypeHfc134a(r-134a)Cfc12(r-12)Hfc134a(r-134a)Compressor installation procedure= 120 cc (4.22 fl oz)= 50 cc (1.76 fl oz)= 70 cc (2.46 fl oz)1. Slowly release the pressure from the schrader valve on the Compressorservice Valve.2. Place Compressor with service valve in upright position and removethe mounting bolts of the service valve (fig.3, see page 14).3. Remove the excess oil from the new Compressor (calculated by theabove mentioned oil inspection procedure (fig.1).4. Install service valve using original bolts and tighten to the specifiedtorque as referred to in the appropriate vehicle repair manual(fig.3, see page 14).5. To install the Compressor to the vehicle refer to the appropriatevehicle repair manual.6. Lubricate and install new o-rings to the suction and discharge hoses.7. Connect the hoses to the Compressor and tighten to the specifiedtorque as referred to in the appropriate vehicle repair manual.OilTypeDenso-oil 8Or equivelantDenso-oil 6Or equivelantDenso-oil 9Or equivelantfig.1fig.2Precautions for Condenser removal1. To reclaim refrigerant from the A/C unit, only use certified recoveryequipment.2. When handling refrigerant, follow the appropriate government safetyregulations.3. To remove the condenser, refer to the appropriate vehicle repairmanual.4. In order to keep moisture out of the system, cap the open fittingsimmediately after disconnecting hoses.5. Always replace receiver/drier.Condenser oil replenishing procedureWhen replacing a condenser, take into account that a certain amountof oil will be left behind in the old condenser. This amount is generallyaround 40cc. This amount must be added to the system after replacingthe condenser.Condenser oil id chartCompressor TypeAllRefrigerant TypeHFC134a (R134a)CFC12 (R-12)Condenser installation procedureOil TypeDENSO-oil 8 or equivelantDENSO-oil 6 or equivelant1. Install condenser with original nuts and bolts and tighten to thespecified torque.2. Lubricate and install new o-rings to gas tube and liquid pipe.3. Connect hose and pipe to the condenser and tighten to the specifiedtorque, as described in the vehicle repair manual.1) remove service valve (A).2) remove excessive oil.3) install service valve.4) tighten bolts (B) to the specified torque value.28 DENSO EUROPE BV