10.07.2015 Views

Magic 600.book

Magic 600.book

Magic 600.book

SHOW MORE
SHOW LESS
  • No tags were found...

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Operator closes thedoor slowly (softstart) whilst dooroperator light flashesThe operatorswitches off duringmotion.Remote transmitter isnot working, LED notalightRemote transmitter isnot workingThe operator cannotbe used via the wallkeypad (optional).The operator cannotbe used via theremote transmitter(optional).Changing the fusePull out mains plug.Operator teaches in the travelautomatically. After CLOSED endposition, moves automatically toOPEN end position. If the dooroperator light flashes in intervals of4, carry outTeaching in the dooroperator (Chapter 15)Check that the door is runningsmoothly and that the entrapmentprotection device is working properly/ Reset / Teach in the door operatorReplace the batteriesIf the function message assigned tothe transmission pulse is notdisplayed whilst the transmitter isactuated (see Chapter 16): Teach inremote transmitter / Poor reception(install optional antenna) energysavinglampsCheck the wall keypad and controlwire.Radio level too weak. There areinterfering radio signals from othertransmission sources / Carry outradio level check as described below• Remove the operator hood, see page 164.• Remove the faulty fuse (S1) from the fuse holder (S2) andreplace it. Make sure that the new fuse has the correctvalue!• Replace the operator hood.Restore the mains connection.Changing the battery of the remotetransmitterOpen the housing cover. Remove the battery, fit a new oneand replace the housing cover.Use only leak-proof batteries. Make sure the polarityis correct. Dispose of used batteries in anenvironmentally-friendly way.23 Maintenance intervalsMonthly• Load switch-off (entrapment protection device)• Emergency lock release• Additional safety devices (if fitted)Every 6 months• Mounting of door operator on the ceiling and on the wall24 Declaration of conformitySee page 167.Declaration of incorporation see page 168.25 Technical dataMains connection230 V~, 50/60 HzDevice fuse1.6 A, T (slow-blow)Power consumption at rated load140 WClosed current< 2 WDegree of protectionFor dry roomsonly, IP 20Protection class 1Wireless remote control433.92 MHz AMRemote transmitter range 1)15 - 50 mRemote transmitter batteries CR 2032 (3 V)Idle speed ~ OPEN >210 mm/s~ CLOSE >140 mm/sTraction600 NRated load150 NStroke length<strong>Magic</strong> 6002890 +/- 25 mm<strong>Magic</strong> 600 long3978 +/- 25 mmTotal length 3)615 +/- 25 mmTotal length 2) 3)485 +/- 25 mmWidth285 mmWidth 2)363 mmInstallation height drive rail40 mmPermissible-20°C to 50 °Cambient temperaturesStorage -20°C to 80 °CLightingE14, max. 40 WMaximum number of duty cycles20per hour at rated loadMaximum number of duty cycles8without a break at rated loadNoise level at a distance of 2 m≤69 dB(A)1) The transmission range of the remote transmitter may bereduced considerably by external interference.2) Dimensions with turned operator head3) plus stroke length26 Replacement partsSee pages 162 and 163.27 Accessories (optional)Available from specialised dealer's:• 4-command multi-use remote transmitter• Wall keypad• Key-operated control• Keypad• Wireless keypad• External antenna• Photo cell• Extension module for opto-sensor• Extension module for warning light• Emergency lock release from outside or inside• Safety rail 8.2 kohms• Potential-free receiver, various frequencies28 Removal, DisposalRemoving the door operator takes place in thereverse sequence of the installation instructionsand must be carried out by qualified technicians.Dispose of the device according to environmentalguidelines. Electrical parts must not be disposed ofas domestic waste. 2002/96/EG (WEEE)<strong>Magic</strong> 600 N000924 12/2010 13 / 208

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!