Air compressor - Lomax

There are no user serviceable parts inside this productexcept those referred to in the manual. Always referservicing to qualified service personnel. Never removeany part of the casing unless qualified to do so; this unitcontains dangerous voltages.Warning!For your protection if this product is to be used outdoorsit should not be exposed to rain or used in damplocations. Do not place the product on damp surfaces,use a workbench if available. For added protection usea suitable residual current device (R.C.D.) at the socketoutlet.Note: If the mains cable requires replacing it must bereplaced with an identical one and fitted by aqualified person.5.4 On/Off switch (ref. 8)5.4.1 D 200/8/24 - D 200/10/24 (Fig. 2a)DN 200/10/xx - DN 230/10/xx (Fig. 2c)D 230/10/50 V (Fig. 2d)To switch on the equipment set the On/Off switch (ref.8) to position I.Move the On/Off switch (ref. 8) to position O to switchoff the equipment.5.4.2 D 200/8/6 - D 115/8/6 SIL (Fig. 2b)To switch on the compressor, pull out the red knob (ref.8) to position I.To switch off the compressor, press the red knob (ref. 8)in again to position O.5.5 Adjusting the pressure● You can adjust the pressure on the pressure gauge(ref. 6) using the pressure regulator (ref. 7).● The set pressure can be taken from the quicklockcoupling (ref. 5).5.6 Setting the pressure switchThe pressure switch is set at the factory.5.6.1 D 200/8/6 - D 115/8/6 SIL - D 200/8/24Switch-on pressure 6 barSwitch-off pressure 8 bar5.6.2 D 200/10/24 - DN 200/10/xx - DN 230/10/xx -D 230/10/50 VSwitch-on pressure 8 barSwitch-off pressure 10 bar6. Cleaning and maintenanceWarning!Pull the power plug before doing any cleaning andmaintenance work on the appliance.Warning!Wait until the compressor has completely cooleddown. Risk of burns!Warning!Always depressurize the tank before carrying outany cleaning and maintenance work.6.1 Cleaning● Keep the safety devices free of dirt and dust as faras possible. Wipe the equipment with a clean cloth orblow it with compressed air at low pressure.● We recommend that you clean the applianceimmediately after you use it.● Clean the appliance regularly with a damp clothand some soft soap. Do not use cleaning agentsor solvents; these may be aggressive to the plasticparts in the appliance. Ensure that no water can getinto the interior of the appliance.● You must disconnect the hose and any spraying toolsfrom the compressor before cleaning. Do not cleanthe compressor with water, solvents or the like.6.2 Condensation waterThe condensation water must be drained off each dayby opening the drain valve (ref. 11) (on the bottom of thepressure vessel).GB18FUNCTIONCleaning of intake filter and/orsubstitution of filtering elementDraining tank condensateMAINTENANCE resumptive tableAFTER THE FIRST100 HOURS●Periodically and at the end of workEVERY 100 HOURS●