Manuale Installatore - Elco Ecoflam

1
INSTALLATION
1.1 Minimum distances
To ensure the appliance is installed correctly, keep to
the minimum distances indicated in the figure on the
right and leave enough room for air to circulate freely.
Use the accessories provided with the appliance
to carry out the installation properly.
Note:
The dimensions of the internal and external units are
given at the back of the manual.
MIN
100 cm
MIN
100 cm
ATTENTION:
- Make sure the installation site and any systems to
which the appliance must be connected comply with
the applicable norms in force.
- Use manual tools and equipment suitable for the
intended use (in particular, make sure that the tool is
not worn and that the handle is intact and fully fastened
to the rest of the tool); use them correctly and
make sure they don’t fall from a height. Put them
safely back in place after use.
(risk of personal injury from falling splinters or fragments,
and damage to the appliance and surrounding
objects).
- When lifting loads with a crane or hoist, make sure
the equipment used for lifting is stable and efficient
and suitably sized for the movement and weight of
the load itself; place the load correctly in slings, tie
ropes around it to limit any oscillations and lateral
movements; lift the load from a position where there
is a full view of all the space covered by the load
during lifting; do not allow people to pass or stop in
the vicinity of the suspended load.
18000 - 24000 - 36000 48000
23