Manuale utente_Owner's manual_Manuel d ... - Husqvarna

ENGINE OIL REPLACEMENT AND MESH FILTERS-FILTER
CARTRIDGE CLEANING OR REPLACEMENT
WARNING*: Be careful not to touch hot
engine oil.
Drain the oil with WARM ENGINE; proceed as follows:
- Remove oil filler cap (2);
- put a drip pan under engine;
- remove oil drainage plug (3);
- evacuate the exhausted oil, and clean magnet on plug (3);
- loosen the two caps (4), and remove the two mesh
filters (5) and (6);
- check for O-rings (7) conditions. If worn, change them.
Then clean filters (5) and (6) using gasoline;
- reassembly is a reverse of removal.
- undo cap (8) and remove cartridge filter (9);
- replace filter (9), lubricate O-ring (10), and screw cap
(8);
- Once the filter has been replaced, refit the oil drainage
plug (3) and carry on as follows:
1) Partially top up with 600cc of oil, refit the filler cap ,
start the engine and let it run at idle for 2 minutes.
2) turn off the engine and wait for at least two minutes
to let oil flow in the sump.
3) Top up as necessary to restore the max. level.
Check the level as indicated in the relevant paragraph.
EN
1
5 7 4
8
2
7
7
4
3
6 7 4
9 10
8
7
7
EN - 25