TXC 511 2013 IE - Husqvarna

ADJUSTING THE SHOCK ABSORBER HYDRAULIC DAMPING
Adjustment of the compression stroke is independent
from the rebound stroke.
A) COMPRESSION - Standard setting:
1) Low damping speed:
- TC - TXC: 13 +1/-2 clicks
- TE: 16 + 1/-2 clicks
(adjuster screw 1)
2) High damping speed:
- TC - TXC: 1 ± 1/2 turns
- TE: 1 ± 1/2 turns
(adjuster screw 2)
To reset the standard setting, turn upper adjusters (1)
and (2) clockwise until reaching fully closed position.
Then turn them back to the above-mentioned positions.
In order to obtain a smooth braking action, turn the adjusters
counter clockwise. Vice versa to obtain a harder
braking action.
B) REBOUND - Standard setting:
- TC - TXC: 13 +1/-2 clicks
- TE: 16 + 1/-2 clicks
To reset the standard setting, turn lower adjuster (3)
clockwise until reaching fully closed position. Then turn it
back by the mentioned clicks.
In order to obtain a smooth braking action, turn the adjuster
counter clockwise. Vice versa to obtain a harder
braking action.
CHAIN ADJUSTMENT
Chain should be checked, adjusted and lubricated as
per the Maintenance Chart to ensure safety and prevent
excessive wear. If the chain becomes badly worn or is
poorly adjusted (i.e., if it is too loose or too taut), it could
escape from sprocket or break.
Check that chain has a max. 5 mm (0.2 in.) gap (A).
WARNING*: Incorrect chain tension involves
excessive and early wear of the
chain slider lower part; Periodically check
for wear and replace it, if worn out.
A
-
2
1
+ - +
3
EN - 40
SPECIFICATIONS - OPERATION - MAINTENANCE