TXC 511 2013 IE - Husqvarna
TXC 511 2013 IE - Husqvarna TXC 511 2013 IE - Husqvarna
To remove spark plug, proceed as follows: - remove the air filter cover; - disconnect connector (1) on engine left side; - on engine right side, undo screw (2) using an 8 mm wrench; - turn spark plug cap (3) complete with coil through 90° and lift it to remove it; then remove spark plug. CAUTION*: Carefully change the spark plug, if necessary, using one having the same rating. Before refitting the plug, thoroughly clean the electrodes and the insulator using a metal brush. Apply graphitised grease on spark plug thread, screw it by hand all the way down, then tighten it to the torque of 10 ÷ 12 Nm (7.38 ÷ 8.85 ft-Ib). Loosen spark plug and tighten it again to 10÷12 Nm (7.38 ÷ 8.85 ft-Ib). Spark plugs which have cracked insulators or corroded electrodes should be replaced. 1 2 3 EN - 30 SPECIFICATIONS - OPERATION - MAINTENANCE
AIR FILTER CHECK - Turn pin (1) counter clockwise and remove saddle from central retaining screw; - release retaining clips (4), and slide filter (5) out of vehicle right side, taking special care not to damage the two retaining hooks; EN 1 - remove right-hand side panel (2) by loosening the five screws (3) using an 8 mm wrench; 4 3 2 5 3 SPECIFICATIONS - OPERATION - MAINTENANCE EN - 31
- Page 36 and 37: REGOLAZIONE POSIZIONE PEDALE FRENO
- Page 38 and 39: SOSPENSIONI Le indicazioni che segu
- Page 40 and 41: LIVELLO OLIO FORCELLA Per il regola
- Page 42 and 43: REGOLAZIONE FRENO IDRAULICO AMMORTI
- Page 44 and 45: Lavaggio catena senza anelli OR (TC
- Page 46 and 47: RIMONTAGGIO RUOTA ANTERIORE - Monta
- Page 48 and 49: SMONTAGGIO PASTIGLIE FRENO - Rimuov
- Page 50 and 51: SOSTITUZIONE LAMPADINE PROIETTORE (
- Page 52 and 53: SOSTITUZIONE LAMPADA LUCE TARGA (TE
- Page 54 and 55: ❏ Freni / Frizione Controllo circ
- Page 57 and 58: TXC TC TE EN TC - TE 449 2013 I.E.
- Page 59 and 60: PRESENTATION Welcome to the Husqvar
- Page 61 and 62: IDENTIFICATION DATA The engine iden
- Page 63 and 64: FRONT BRAKE Fixed disc type .....
- Page 65 and 66: LEGEND 1. Front wheel 2. Front brak
- Page 67 and 68: LEGEND 1. Front wheel 2. Front brak
- Page 69 and 70: SIDE STAND A side stand (1) is supp
- Page 71 and 72: 2- SPEED / CLOCK (figure 2) - SPEED
- Page 73 and 74: STEERING LOCK (TE) The motorcycle i
- Page 75 and 76: GEAR SHIFT CONTROL The lever (1) is
- Page 77 and 78: ENGINE STARTING (TE-TXC) With cold
- Page 79 and 80: STOPPING THE MOTORCYCLE AND THE ENG
- Page 81 and 82: ENGINE OIL REPLACEMENT AND MESH FIL
- Page 83 and 84: - Pour the necessary quantity of co
- Page 85: IDLE ADJUSTMENT Adjust the carburet
- Page 89 and 90: ADJUSTMENT OF THE CONTROL LEVER AND
- Page 91 and 92: REAR BRAKE FLUID LEVEL CHECK Fluid
- Page 93 and 94: ADJUSTING THE FRONT FORK a) COMPRES
- Page 95 and 96: ADJUSTING THE SHOCK ABSORBER SPRING
- Page 97 and 98: If it is not, proceed as follows: -
- Page 99 and 100: REMOVING THE FRONT WHEEL Set a stan
- Page 101 and 102: TYRES BRAKES Care should be taken t
- Page 103 and 104: BATTERY The sealed battery does not
- Page 105 and 106: To replace the parking light bulb (
- Page 107 and 108: APPENDIX LONG PERIOD OF INACTIVITY
- Page 109: ALPHABETICAL INDEX Page A ADJUSTING
- Page 112 and 113: SOMMAIRE Page PRÉSENTATION........
- Page 114 and 115: IMPORTANT Pour maintenir la « Gara
- Page 116 and 117: FR - 6 DONNÉES TECHNIQUES MOTEUR T
- Page 118 and 119: VUE GÉNÉRALE DE LA MOTO - TE 16 1
- Page 120 and 121: VUE GÉNÉRALE DE LA MOTO - TC - TX
- Page 122 and 123: ROBINETS CARBURANT COMMANDES Les de
- Page 124 and 125: AFFICHEUR NUMÉRIQUE, VOYANTS (TE)
- Page 126 and 127: POIGNÉE DES GAZ La poignée (1) de
- Page 128 and 129: BOUTON D'ARRÊT MOTEUR (TC) Le bout
- Page 130 and 131: LOCALISATION DES PROBLÈMES DE FONC
- Page 132 and 133: DÉMARRAGE DU MOTEUR (TC) Le moteur
- Page 134 and 135: ARRÊT DU MOTEUR EN ÉTAT D'URGENCE
AIR FILTER CHECK<br />
- Turn pin (1) counter clockwise and remove saddle<br />
from central retaining screw;<br />
- release retaining clips (4), and slide filter (5) out of<br />
vehicle right side, taking special care not to damage<br />
the two retaining hooks;<br />
EN<br />
1<br />
- remove right-hand side panel (2) by loosening the<br />
five screws (3) using an 8 mm wrench;<br />
4<br />
3<br />
2<br />
5<br />
3<br />
SPECIFICATIONS - OPERATION - MAINTENANCE<br />
EN - 31