TXC 511 2013 IE - Husqvarna

ENGINE OIL REPLACEMENT AND MESH FILTERS-FILTER
CARTRIDGE CLEANING OR REPLACEMENT
WARNING*: Be careful not to touch hot
engine oil.
Drain the oil with WARM ENGINE; proceed as follows:
- Remove oil filler cap (2);
- put a drip pan under engine;
- remove oil drainage plug (3);
- evacuate the exhausted oil, and clean magnet on plug (3);
- loosen the two caps (4), and remove the two mesh
filters (5) and (6);
- check for O-rings (7) conditions. If worn, change them.
Then clean filters (5) and (6) using gasoline;
- reassembly is a reverse of removal.
- undo cap (8) and remove cartridge filter (9);
- replace filter (9), lubricate O-ring (10), and screw cap
(8);
- Once the filter has been replaced, refit the oil drainage
plug (3) and carry on as follows:
1) Partially top up with 600cc of oil, refit the filler cap
, start the engine and let it run at idle for 2 min-
utes.
2) turn off the engine and wait for at least two minutes
to let oil flow in the sump.
3) Top up as necessary to restore the max. level.
- Check the level as indicated in the relevant paragraph.
EN
1
5 7 4
8
2
7
7
4
3
6 7 4
9 10
8
7
7
SPECIFICATIONS - OPERATION - MAINTENANCE
EN - 25