TXC 511 2013 IE - Husqvarna

ENGINE STARTING (TC)
With cold engine, i.e., after the motorcycle has not
been used for a while or in low ambient temperatures,
operate in the following manner:
1) Pull starter knob (1);
2) Pull clutch lever (2) and hold it in place;
3) Shift gear pedal (3) to neutral position;
4) Press the starter button (4), then release clutch lever
(1).
Take starter knob (1) back to its initial position as
soon as engine stays idle. When starting with an
already warmed up engine DO NOT USE the starter.
When a cold engine has just been started, do not
increase revs, to ensure an adequate oil warm-up
and circulation.
Note*:
A safety switch allowing to start engine ONLY when
the clutch lever is pulled is assembled onto clutch
lever mount.
IMPORTANT
NEVER START ENGINE WITH BATTERY DIS-
CONNECTED FROM CIRCUIT.
2
1
4
IMPORTANT NOTE IN CASE OF COLD START AT LOW TEM-
PERATURES
It is recommended to briefly warm up the engine at idle
until, after having turned off the starting device, the engine
response when opening the throttle is normal.
This allows oil reaching all points that need lubricating and
coolant to warm up to regular operating temperature.
Avoid warming up the engine for too long.
IMPORTANT
DO NOT OPERATE THE THROTTLE CON-
TROL WHILE STARTING-UP.
N
3
EN - 22
SPECIFICATIONS - OPERATION - MAINTENANCE