TXC 511 2013 IE - Husqvarna

TROUBLESHOOTING
The following list is used for troubleshooting and to find
the necessary remedies.
The engine does not start
- the starting procedures are not correctly followed: follow
the instructions given on paragraph “Starting the
engine”
- dirty spark plug: clean
- the spark plug does not spark: adjust the electrodes gap
- faulty starter motor: repair or replace
- faulty start button: replace the switch
The engine has starting troubles
- dirty or worn out spark plug: clean or replace
The engine starts, but it is erratic
- dirty or worn out spark plug: clean or replace
- faulty spark plug electrode gap: adjust
The spark plug gets easily dirt:
- unfit spark plug: replace
The engine overheats
- the air flow on the radiators is blocked: clean
- Faulty cooling fan (TE - TXC): replace thermal switch
- insufficient quantity of oil: top up
The engine knocks
- excessive carbon deposit on the piston crown, or in the
combustion chamber: clean
- faulty spark plug or wrong heat rating: replace
The alternator fails to charge, or its charge is insufficient
- the cables on the voltage regulator are badly connected,
or in short-circuit: correctly connect, or replace
- faulty alternator coil: replace
- demagnetised alternator rotor: replace
- faulty voltage regulator: replace
The battery overheats
- faulty voltage regulator: replace
Difficulty in shifting gears
- engine oil with too high viscosity rating: replace with
the recommended oil
The clutch slips
- insufficient spring load: replace
- worn-out clutch plates: replace
Faulty brakes
- worn-out pads: replace
The engine lacks power
- dirty air filter: clean
- the spark plug electrode gap is too large: adjust
- incorrect valve clearance: adjust
- insufficient compression: check for the cause
EN - 20
SPECIFICATIONS - OPERATION - MAINTENANCE