TXC 511 2013 IE - Husqvarna

REPLACING THE NUMBER PLATE BULB (TE)
- loosen screw (1) and remove the number plate bulb
(2) from the mudguard;
- take bulb holder (3) and bulb (4) out of the support;
- pull the bulb (4) to detach it from bulb holder.
Once the bulb has been replaced, reverse the above procedure
to reassemble.
1
2
HEADLIGHT ADJUSTMENT (TE)
When checking the proper aiming of the headlight beam:
inflate tyres at the right pressure, have a person sit
astride the motorcycle and set the motorcycle perpendicular
to its longitudinal axis
In front of a wall or a screen positioned at a distance of
10 metres (32.8 ft), draw a horizontal line corresponding
to headlight centre height, and a vertical line aligned
with vehicle longitudinal axis.
If possible, execute this operation in a shaded place.
When the low beam is on, the upper edge between dark
and lit zone should be at 9/10th of headlight centre
from ground.
Beam height can be adjusted as follows:
- Work adjuster screw (1);
tighten to lower the beam,
loosen to raise the beam.
Once set, reverse the above procedure to reassemble.
3
4
1
EN - 50
SPECIFICATIONS - OPERATION - MAINTENANCE