HKF 200 - Karcher

Troubleshooting
Fault Possible cause Remedy of whom
Motor does not turn. There is no voltage at the motor. Check fuses and cables. Electricians
Motor does not turn, cleaning
head does not turn
Cleaning head turns too
abruptly
Protective motor switch was triggered.
Error current protective switch
was triggered.
No compressed air present or
pressure too low.
Compressed air supply line
kinked.
Mechanical defect on:
– Coupling parts
– Drive shaft
– Gears
Worn drive discs cause increased
bevel play.
Fix cause for overload, reset motor protection
switch.
Remove cause and reset error current protective
switch.
Check compressed air supply.
Check compressed air hoses.
Check parts and replace defective parts.
Replace drive discs.
Electricians
Electricians
Operator
Operator
Customer Service
Customer Service
Destroyed gears on bevel wheels. Replace bevel wheels. Customer Service
Uneven cleaning jet Spray nozzles clogged. Clean spray nozzles. Operator
Spray nozzles damaged. Replace spray nozzles. Operator
Description
Accessories
Maintenance unit for compressed
air (only for compressed
air drive)
Compressed air filter with
automatic condensate
drain (only for compressed
air drive)
Bow (stainless steel) for
HKF 200 P, HKF 200 PT
Bow (stainless steel) for
HKF 200 E, HKF 200 ET,
HKF 200 C, HKF 200 C2
Horizontal rack (stainless
steel), diameter 560 mm
Order No.
6.610-020
6.414-154
4.034-016
4.034-126
4.210-022
High pressure hose
NW 13 - 1.5 m *1) 6.389-126
High pressure hose 4.440-173
NW 13 -10 m *1)
Kupplung NW 13 * 4.403-002
90° screwed coupling 4.408-023
NW 13 *
Compressed air hose
(sold by the meter)
Exhaust air silencer with
oil separator
6.388-192
on request
*
Possible for max. 4,000 l/h flow of cleaning
liquid. With higher flow volumes of cleaning
liquids, please consult Kärcher.
1)
The hoses for solvent operation must be
electrostatically conductive!
We hereby declare that the machine described
below complies with the relevant
basic safety and health requirements of the
EU Directives, both in its basic design and
construction as well as in the version put
into circulation by us. This declaration shall
cease to be valid if the machine is modified
without our prior approval.
5.957-454
5.957-735
CE declaration
Product: Internal cleaner
Type: HKF 200
Relevant EU Directives
98/37/EC (to 28.12.2009)
2006/42/EC (from 29.12.2009)
94/9/EC
Applied harmonized standards
EN ISO 12100–1
EN ISO 12100–2
EN 1127-1: 1997
EN 13463-1: 2002
EN 13463-5: 2003
HKF 200 E, HKF 200 ET, HKF 200 C, HKF
200 C2:
EN 60204–1
Applied national standards
-
ID no. of notified body
0123
TÜV SÜD
Ridlerstr. 65
80339 München
Test report no.
Ex5 0307 10088 097
Marking
II 1/2 G c T4
II 1/3 D c 120°C
The undersigned act on behalf and under
the power of attorney of the company management.
CEO
Head of Approbation
Alfred Kärcher GmbH Co. KG
Alfred-Kärcher-Str. 28 - 40
D - 71364 Winnenden
Phone: +49 7195 14-0
Fax: +49 7195 14-2212
Warranty
The warranty terms published by our competent
sales company are applicable in
each country. We will repair potential failures
of the appliance within the warranty
period free of charge, provided that such
failure is caused by faulty material or defects
in fabrication.
In the event of a warranty claim please contact
your dealer or the nearest authorized
Customer Service centre. Please submit
the appliance, including all accessories,
and the proof of purchase.
34 English