INSTRUCTION MANUAL - Team ORION JAPAN

ENGLISH
Press the ENTER KEY to display the final charge or discharge data (depending on the cycle mode).
Charge end data screen
Discharge end data
Storage charge mode
From the main screen, press the + or – key to select
storage mode (indicated by „STORAGE“).The special
storage mode will discharge and/or recharge your NiMH,
NiCd, LiPo or LiFe battery so that it is in optimal state for
storage. Doing this will minimize the risk of cell damage
due to deep discharge if the battery is stored for a long
period of time.
ENGLISH
Press the BATT TYPE key to display the battery internal resistance and individual cell voltage (only
for LiPo/LiFe with balancing connector).
The charge and discharge settings of the actual memory profile will be used, make sure that the
settings are compatible with the battery.
Press the ENTER key to go back to the cycle screen.
Press and hold the ENTER key. The battery check will
be displayed.
If the battery is properly connected and functional, the storage charge will start. If the selected battery
type is NiMH or NiCd, the battery will be discharged, then recharged to 50% of the selected capacity.
With LiPo and LiFe batteries, the battery will be recharged and balanced to 3.85V/cell for LiPo and
3.3V/cell for LiFe. If the voltage is above 3.85V/cell for LiPo and 3.3V/cell for LiFe, the storage charge
will stop as there is enough energy stored inside the batteries for a safe storage.
24
Team Orion Advantage Race Spec
www.teamorion.com 25