You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Angle adjustment roller brush<br />
In order to sweep the dirt to the side, the<br />
roller brush can be swivelled to the left or<br />
right.<br />
This is also a benefit for removing snow by<br />
means of the snow removal shield upgrade<br />
kit.<br />
Tilt the swivel bracket forwards until the<br />
notch is free.<br />
Swivel to the left or right, depending on<br />
which side you wish to sweep the dirt to.<br />
Tilt swivel bracket backwards and snap<br />
into place.<br />
Driving operations<br />
Release parking brake.<br />
Pull clutch lever for travel drive.<br />
Note: The driving speed is fixed and<br />
cannot be modified.<br />
Release clutch lever for travel drive.<br />
Device comes to a halt.<br />
Roller brush drive<br />
Pull the lever for the roller brush drive,<br />
roller brush is turning.<br />
Release the lever for roller brush drive.<br />
Roller brush comes to a halt.<br />
Turn off the appliance<br />
Release clutch lever for roller brush<br />
drive and travel drive.<br />
Gas lever to "OFF" position.<br />
Close the fuel supply.<br />
Turn the rotating knob perpendicular to<br />
the fuel tap.<br />
Activate immobilising brake.<br />
Transport<br />
Danger<br />
Risk of injury and damage! Observe the<br />
weight of the appliance when you transport<br />
it.<br />
Switch off engine.<br />
Empty fuel tank.<br />
Secure the machine with tensioning<br />
straps or cables.<br />
When transporting in vehicles, secure<br />
the appliance according to the guidelines<br />
from slipping and tipping over.<br />
Note: Do not kink the bowden or sheathed<br />
cables.<br />
Storage<br />
Danger<br />
Risk of injury and damage! Note the weight<br />
of the appliance in case of storage.<br />
Park the machine in a safe and dry<br />
place.<br />
Activate immobilising brake.<br />
12 EN<br />
Shutdown<br />
Follow operating instructions of the engine<br />
manufacturer!<br />
If the sweeper is going to be out of service<br />
for a longer time period, observe the following<br />
points:<br />
Park the sweeper on an even surface.<br />
Switch off engine.<br />
Allow engine to cool down.<br />
Drain the fuel tank and the carburettor.<br />
Change engine oil.<br />
Raise roller brush. In order to do this,<br />
turn the height adjustment all the way to<br />
the top (direction –).<br />
Clean the device.<br />
Park the machine in a safe and dry<br />
place.<br />
Activate immobilising brake.<br />
Note: For description, see section on Care<br />
and maintenance.<br />
Maintenance and care<br />
Caution<br />
Switch off the motor and unplug the spark<br />
plug connector prior to performing repair,<br />
maintenance or cleaning tasks.<br />
General notes<br />
Please note that only the handling of the<br />
engine that is necessary for operating<br />
the sweeper is explained in these instructions.<br />
For all other information on the motor<br />
please refer to the enclosed operating<br />
manual of the manufacturer of the engine!<br />
– Maintenance work may only be carried<br />
out by approved customer service outlets<br />
or experts in this field who are familiar<br />
with the respective safety<br />
regulations.<br />
– Mobile appliances used for commercial<br />
purposes are subject to safety inspections<br />
according to VDE 0701.<br />
Cleaning<br />
Caution<br />
Do not clean the appliance with a water<br />
hose or high-pressure water jet (danger of<br />
short circuits or other damage).<br />
Cleaning the device<br />
Clean the machine with a damp cloth<br />
which has been soaked in mild detergent.<br />
Note: Do not use aggressive cleaning<br />
agents.<br />
Maintenance intervals<br />
Maintenance by the customer<br />
Note: With a new motor, the oil must be<br />
changed after the first 5 operating hours.<br />
In order to safeguard warranty claims, all<br />
service and maintenance work during the<br />
warranty period must be carried out by the<br />
authorised KÄRCHER specialist in accordance<br />
with the maintenance booklet.<br />
- 4<br />
Note: Where maintenance is carried out by<br />
the customer, all service and maintenance<br />
work must be undertaken by a qualified<br />
specialist. If required, a specialised Kärcher<br />
dealer may be contacted at any time.<br />
Note: For description, see section on Maintenance<br />
work.<br />
Daily maintenance:<br />
Check engine oil level.<br />
Check air filter.<br />
Check tyre pressure.<br />
Check the roller brush for wear and<br />
wrapped belts.<br />
Check the height adjustment of the roller<br />
brush.<br />
Check for smooth running of the<br />
Bowden cables and the moveable parts<br />
Maintain every 3 months or 25 hours of<br />
operation:<br />
Clean air filter.<br />
Note: If the appliance is frequently used<br />
in a dusty environment, maintain more<br />
frequently.<br />
Maintain every 6 months or 50 hours of<br />
operation:<br />
Perform a motor oil change.<br />
Check spark plug.<br />
Maintain every 2 years or 250 hours of<br />
operation:<br />
Replace the air filter.<br />
Replace the spark plug.<br />
Maintenance by Customer Service<br />
Maintenance after the first month or 5 operating<br />
hours:<br />
Carry out initial inspection.<br />
In order to safeguard warranty claims, all<br />
service and maintenance work during the<br />
warranty period must be carried out by the<br />
authorised KÄRCHER specialist in accordance<br />
with the maintenance booklet.<br />
Maintenance Works<br />
Preparation:<br />
Park the sweeper on an even surface.<br />
Activate immobilising brake.<br />
General notes on safety<br />
Danger<br />
Risk of injury!<br />
The engine requires approx. 3-4 seconds<br />
to come to a standstill once it has been<br />
switched off. During this time, stay well<br />
clear of the working area.<br />
– Allow the machine sufficient time to cool<br />
down before carrying out any maintenance<br />
and repair work.<br />
– Do not touch any hot parts, such as the<br />
drive motor and exhaust system.<br />
Note: The appliance may only be tilted<br />
backwards if the fuel tank is empty.<br />
Check the tyre pressure<br />
Park the sweeper on an even surface.<br />
Connect air pressure testing device to<br />
tyre valve.<br />
Check air pressure and adjust if required.<br />
For permissible tyre air pressures see<br />
"Technical data".