airlanco_flush_floor_6_25_08_rebrand

Recommendations

Info

800-500-9777NOTE: These are strictly suggestions for the installation of the flush flooraeration system. There are many methods to get to the same end result,this is just one method. Contractor or installer may have experience withanother method.CORRUGATEDPERFORATEDSHEETSSHEETSUPPORTSS STRIPCORRUGATEDSOLID SHEETSTUNNEL TRANSITIONFAN INLETSystem Plan ViewCORRUGATEDSHEETSHEETSUPPORTTunnel Cross SectionFAX 402-245-51962www.airlanco.com
800-500-9777INSTALL AERATION FLOOR SUPPORTSReference manufacturer’s tank aeration drawing for general constructionguidelines and details. See also the example on the following page anddrawing #12682 on page 7 for additional suggested flush floor supportdetails. Cut ½” stabilizing rod into suitable lengths to join the supportstogether. This length will depend on the number of supports and thewidth of the tunnel. Field weld every four feet alternating top and bottom.See “Typical Support Layout” drawing #12682 for details. Contractor orinstaller may have experience with another cut schedule that worksbetter.NOTE: Field weld all support joints.NOTE: Supports will need to be trimmed to fit around the TunnelStiffener (if required). DO NOT WELD SUPPORTS TO TUNNELSTIFFENER.FAX 402-245-51963www.airlanco.com
Page 1: ®Flush Floor AerationInstallation
Page 5 and 6: 800-500-9777FLOOR PANEL INSTALLATIO

airlanco_flush_floor_6_25_08_rebrand

Create successful ePaper yourself

Delete template?

Save as template?