Philips Parasurtenseur pour Home Cinéma - Guide de mise en route - AEN

EN
Additional information about your energy efficient surge protector
Features
Your energy efficient surge protector is specifically designed to fit within
your home theater setup. You can conveniently control the on/off of your
devices in either zone 1 or zone 2 outlets with your remote control. When
switched to the off position, it eliminates the consumption of the stand-by
power to these outlets, bringing energy savings to your fingertips.
Zone 1 & 2 outlets group your devices by usage.
TV
AMP
STB
DVD
Always on outlets remain on even when other outlets are switched off
– these are ideal for devices which have volatile memory and require
constant power. (i.e. cable modems, DVRs , set top boxes, etc)
Zone 2 Zone 1
Remote control turns your devices on/off in zone 1 & zone 2 with the
touch of a button.
Cable management clips help eliminate cable clutter.
LED indicators on the front of the unit provide worry-free protection and
show that your surge protector functions properly.
Power – (blue) shows that the power is running to your devices.
Protecting – (red) shows that your surge protector is actively
protecting your devices.
Zone 1 & Zone 2 – (green) lights to show that the group of outlets
have been switched on.
Remote control
Always on
Cable management clips
POWER
ZONE 1 ZONE 2
PROTECTING
Instructions for changing the remote control battery
NOTE: If the remote control device stops working, replace the battery.
Step 1 - Turn the unit over and slide open the battery compartment cover.
Step 2 - Remove and dispose of the old battery properly. Do not throw the old
battery in the trash.
Step 3 - Insert a new battery and close the compartment cover. Replace ONLY
with a 3 volt CR2032 type button cell battery.
This device complies with part
15 of the FCC Rules.
Operation is subjec to the
fo lowing two conditions:
(1) This device may not cause
harmful interference,and
(2) This device must accept any
interference received,including
interference that may cause
undesired operation
Ch. A
Made in China
RF Remote Control
FCC ID: OYMSPP5107C
NOTE: The remote control with this unit operates on either channel A or channel B frequency. If you have purchased
more than one unit, make sure you have two different frequencies (A and B) as indicated by stickers on the bottom of
the unit and on the packaging.

Instructions for attaching the base to the surge protector unit
Step 1
Align tabs of the supplied base unit
to the slots on the bottom of the
surge protector, then snap them
into place.
Step 2
Align the cable management clips
into the grooves on the base of
the unit.
Step 3
Follow the direction of the arrow
as indicated and snap the cable
management clips into place.
PWR SRG_insert_EN_V1.0
wk10113