9. Schaltgerät - Kessel

4. Installation and assemblyA standard plastic pipe muff can be pushed over the connectingpiece (see Fig. C).Alternatively, the connection of a plastic pipe with DN 100 forthe inlet or DN 70 for ventilation can be carried out usingconnection clamps or rubber hoses with hose clamps*. Toprevent the high tension forces leading to deformation at theconnecting piece, a suitable supporting ring* must be pushedinto the upper end of the connecting piece (see Fig. D).Saw offconnecting piecesTransitionhose piecePipe connectionHoseclampsSaw off connectingpiecesHoseclampSupporting ringInlet connectionAbb. D:II. Connections attached to the pre-scored areas atthe side (for inlet pipe or manual diaphragm pump) usingbore hole with saw cap*, fitting of a suitable greases seal*and insertion of a suitable plastic pipe (see Fig. E)Tank-lifting stationPipe duct sealAbb. C:Pipe connectionOpening drilledTank-lifting stationAbb. E* KESSEL accessory part54