GAS GRILL - Ashwood Hearth & Home Energy & Fireplace
GAS GRILL - Ashwood Hearth & Home Energy & Fireplace GAS GRILL - Ashwood Hearth & Home Energy & Fireplace
30MAINTENANCEWEBER ® SPIDER /INSECT SCREENSYour Weber ® gas barbecue, as well as any outdoor gas appliance, is a target for spidersand other insects. They can nest in the venturi section (1) of the burner tubes. Thisblocks the normal gas fl ow, and can cause the gas to fl ow back out of the combustionair opening. This could result in a fi re in and around the combustion air openings, underthe control panel, causing serious damage to your barbecue.The burner tube combustion air opening is fi tted with a stainless steel screen (2) toprevent spiders and other insects access to the burner tubes through the combustion airopenings.We recommend that you inspect the Spider/Insect screens at least once a year.(See Section “Annual Maintenance”.) Also inspect and clean the the Spider/Insectscreens if any of the following symptoms should ever occur:1) The smell of gas in conjunction with the burner fl ames appearing yellow and lazy.2) Barbecue does not reach temperature.3) Barbecue heats unevenly.4) One or more of the burners do not ignite.12 DANGERFailure to correct the above mentioned symptoms may resultin a fire, which can cause serious bodily injury or death, andcause damage to property.MAIN BURNER CLEANING PROCEDURETurn off the gas supply.Remove the manifold (See “Replace Main Burners”).Look inside each burner with a fl ashlight.Clean the inside of the burners with a wire (a straightened-out coat hanger will work).Check and clean the air shutter opening at the ends of the burners. Check and cleanthe valve orifi ces at the base of the valves. Use a Steel bristle brush to clean outside ofburners. This is to make sure all the burner ports are fully open. CAUTION: Do not enlarge the burner ports when cleaning.REPLACE MAIN BURNERS1) Your Summit ® gas grill must be off and cool.2) Turn gas off at source.3) Disconnect gas supply.4) Remove cooking grates.5) Remove smoker box.6) Remove Flavorizer ® bars.REMOVE CONTROL PANEL7) Part required: Phillips Screwdriver.a) Remove the burner control knobs.b) Remove the two screws that secure the controlpanel to the frame.c) Remove the control panel. Tilt panel forward andlift up and away from grill. Completely removethe control panel from the cooking box assemblyexposing the valves, burners, igniter, and manifold.bcaWWW.WEBER.COM ®
3131WWW.WEBER.COM ®8) Remove the two screws that secure the manifold to the cookbox. Pull manifoldassembly out from the manifold frame.9) Pull the selected burner(s) tube(s) from manifold frame and replace with a newburner tube.10) To reinstall the manifold assembly, reverse steps 7 through 9. CAUTION: The burner openings (A) must be positionedproperly over the valve orifices (B).Make sure the opposite end of the burner tubes (C) properlyalign into the slots on the backside of the cookbox. Checkproper assembly before fastening manifold in place. WARNING: After reinstalling the gas lines, they should beleak checked with a soap and water solution before usingthe grill. (See, “Check for gas leaks.”)AnNNUAL MAINTENANCEInspection and cleaning of the Spider/Insect screensTo inspect the Spider/Insect screens, remove the control panel. If there is dust or dirt onthe screens, remove the burners for cleaning the screens.Brush the Spider/Insect screens lightly with a soft bristle brush (i.e. an old toothbrush). CAUTION: Do not clean the Spider/Insect screens with hardor sharp tools. Do not dislodge the Spider/Insect screens orenlarge the screen openings.Lightly tap the burner to get debris and dirt out of the burner tube. Once the Spider/Insect screens and burners are clean replace the burners.If the Spider/Insect screen becomes damaged or cannot be cleaned, please contact theCustomer Service Representative in your area using the contact information on our website. Log onto www.weber.com ® .MAIN BURNER FLAME PATTERNThe Weber ® gas barbecue burners have been factory set for the correct air and gasmixture. The correct fl ame pattern is shown.1) Burner tube2) Tips occasionally fl icker yellow3) Light blue4) Dark blueIf the fl ames do not appear to be uniform throughout the burner tube, follow the burnercleaning procedures.CMAINTENANCE91A8B234
- Page 2 and 3: 2DANGERS AND WARNINGS DANGERFailure
- Page 4 and 5: 6206506206504PARTS LIST, LISTE DES
- Page 6 and 7: 6EXPLODED VIEW LIST S-620LISTA DEL
- Page 8 and 9: 8EXPLODED VIEW LIST S-650LISTA DEL
- Page 10 and 11: 1063 - 3 -ASSEMBLY, ASSEMBLAGE, ENS
- Page 12 and 13: 1212ASSEMBLY, ASSEMBLAGE, ENSAMBLAJ
- Page 14 and 15: 14GENERAL INSTRUCTIONSSlide out Bot
- Page 16 and 17: 16GAS INSTRUCTIONS2) Remove the two
- Page 18 and 19: 18GAS INSTRUCTIONSCheck:1) Main gas
- Page 20 and 21: 20OPERATING INSTRUCTIONSGRILLING TI
- Page 22 and 23: 22OPERATING INSTRUCTIONSLIGHTING TH
- Page 24 and 25: 24OPERATING INSTRUCTIONSMANUALLY LI
- Page 26 and 27: 26OPERATING INSTRUCTIONSLIGHTING TH
- Page 28 and 29: 28OPERATING INSTRUCTIONSOPERATING T
- Page 32 and 33: GAS GRILLGuía del Propietario de l
- Page 34 and 35: 34INSTRUCCIONES GENERALESLa barbaco
- Page 36 and 37: 36INSTRUCCIONES SOBRE EL GASTIPO DE
- Page 38 and 39: 38INSTRUCCIONES SOBRE EL GASVerifiq
- Page 40 and 41: 40INSTRUCCIONES DE OPERACIÓNMÉTOD
- Page 42 and 43: 42INSTRUCCIONES DE OPERACIÓNENCEND
- Page 44 and 45: 44INSTRUCCIONES DE OPERACIÓNCÓMO
- Page 46 and 47: 46INSTRUCCIONES DE OPERACIÓN• No
- Page 48 and 49: 48INSTRUCCIONES DE OPERACIÓNENCEND
- Page 50 and 51: 50MANTENIMIENTO DEL QUEMADOR LATERA
- Page 52 and 53: 52MANTENIMIENTO8) Retire los dos to
- Page 54 and 55: 54MISES EN GARDE DANGERLe non respe
- Page 56 and 57: 56INSTRUCTIONS GENERALESSortez le p
- Page 58 and 59: 58INSTRUCTIONS RELATIVES AU GAZ2) R
- Page 60 and 61: 60INSTRUCTIONS RELATIVES AU GAZVér
- Page 62 and 63: 62INSTRUCTIONS POUR L’UTILISATION
- Page 64 and 65: 64INSTRUCTIONS POUR L’UTILISATION
- Page 66 and 67: 66INSTRUCTIONS POUR L’UTILISATION
- Page 68 and 69: 68INSTRUCTIONS POUR L’UTILISATION
- Page 70 and 71: 70INSTRUCTIONS POUR L’UTILISATION
- Page 72 and 73: 72MAINTENANCEGRILLES ANTI-ARAIGNEES
- Page 74 and 75: ATTENTION: This product has been sa
- Page 76: Thanks for sharing your contact inf
30MAINTENANCEWEBER ® SPIDER /INSECT SCREENSYour Weber ® gas barbecue, as well as any outdoor gas appliance, is a target for spidersand other insects. They can nest in the venturi section (1) of the burner tubes. Thisblocks the normal gas fl ow, and can cause the gas to fl ow back out of the combustionair opening. This could result in a fi re in and around the combustion air openings, underthe control panel, causing serious damage to your barbecue.The burner tube combustion air opening is fi tted with a stainless steel screen (2) toprevent spiders and other insects access to the burner tubes through the combustion airopenings.We recommend that you inspect the Spider/Insect screens at least once a year.(See Section “Annual Maintenance”.) Also inspect and clean the the Spider/Insectscreens if any of the following symptoms should ever occur:1) The smell of gas in conjunction with the burner fl ames appearing yellow and lazy.2) Barbecue does not reach temperature.3) Barbecue heats unevenly.4) One or more of the burners do not ignite.12 DANGERFailure to correct the above mentioned symptoms may resultin a fire, which can cause serious bodily injury or death, andcause damage to property.MAIN BURNER CLEANING PROCEDURETurn off the gas supply.Remove the manifold (See “Replace Main Burners”).Look inside each burner with a fl ashlight.Clean the inside of the burners with a wire (a straightened-out coat hanger will work).Check and clean the air shutter opening at the ends of the burners. Check and cleanthe valve orifi ces at the base of the valves. Use a Steel bristle brush to clean outside ofburners. This is to make sure all the burner ports are fully open. CAUTION: Do not enlarge the burner ports when cleaning.REPLACE MAIN BURNERS1) Your Summit ® gas grill must be off and cool.2) Turn gas off at source.3) Disconnect gas supply.4) Remove cooking grates.5) Remove smoker box.6) Remove Flavorizer ® bars.REMOVE CONTROL PANEL7) Part required: Phillips Screwdriver.a) Remove the burner control knobs.b) Remove the two screws that secure the controlpanel to the frame.c) Remove the control panel. Tilt panel forward andlift up and away from grill. Completely removethe control panel from the cooking box assemblyexposing the valves, burners, igniter, and manifold.bcaWWW.WEBER.COM ®
Change language