Manual de instrucciones - Virutex

"c""H2"11. MORTISING EDGE TRIMMING ON A DOOR• Place the door vertically and fasten well so that it does notmove. If the door is already mounted on the frame, place wedgesunder it to prevent it from moving.MEASURING AND TRACING REFRENCES• Place the lock against the door so that the path for the doorknob or handle is at the desired height from the ground “H0”(Fig. 9) and mark the point “0” (Fig. 9) on the face and edge ofthe door.• Measure the distance “H2” (Fig. 9) from the centre of the handleto the centre of the box for the lock."rs""rs""rs""0""c""H2""0""c"Pt"c""H0""0""c""H2"(Figure 9)• Mark the centre "c" of the box for the lock onto the edgeof the door using the tracing template “Pt” (Fig. 9), whichcomes with the equipment.This template has a set of grooves 5 mm apart. You must placethe template onto the edge of the door so that the mark “0” (Fig.9) is lined up with the groove that corresponds to the measurement“H2” (Fig. 9) made earlier (20 mm in Fig. 9). Now make the"c" mark (Fig. 9) on the lower edge of the template.• Trace the upper reference “rs” (Fig. 9) which acts as a referencefor attaching the machine to the door.To do this, place the lower edge of the tracing template “Pt” (Fig.9) on the mark "c” (Fig. 9) and mark the point “rs” (Fig. 9) on theupper edge of the template.20 - FC116U / Operating instructions