Manual de instrucciones - Virutex

FC116U LOCK MORTISERIMPORTANTRead these OPERATING INSTRUCTIONS and the attached GENE-RAL SAFETY INSTRUCTIONS LEAFLET carefully before using themachine. Make sure you have understood them before operatingthe machine for the first time. Keep both sets of instructions forany future queries.1. TECHNICAL INFORMATIONUniversal motor.............................................................................50/60 HzPower................................................................................................1,100 WNo-load speed..........................................................................23,000 min -1Maximum bit diameter....................................................................30 mmMaximum trimming depth......................................................0-125 mmMaximum trimming width...................................................bit diameterMaximum trimming length.................................177 mm + bit diameterMaximum opening of the clamp vises........................................190 mmMaximum grip of the clamp vises....................................................13 mmSide movement of the bit over thickness of door...........+/- 15 mmWeight...................................................................................................14 KgWeighted equivalent continuous acoustic pressure level A......88 dBAAcoustic power level A.........................................................................99 dBAUncertainty......................................................................................K = 3 dbAWear ear protection!Vibration total values............................................................a h: 2.6 m/s 2Uncertainty................................................................................K: 1.5 m/s 22. USEThe FC116U portable lock mortiser is an electrical tool, for thetrimming of mortises to mount door locks, mortise assemblies,etc.In addition to the box for the lock, you can also trim the fittingfor the front plate of the lock. With the help of the tool UC16I,which comes with the equipment, you can drill the entry pointsin the door for the cylinder and the handle.16 - FC116U / Operating instructions