AC30C2X/AC30C2/AC15C1 Owner's Manual - Vox

3. EFFECTS LOOP jack (AC30C2(X) only)The EFFECTS LOOP allows effects to be added further down the signal chain,rather than just plugging them in line with your guitar and amplifier. By using theEffects loop with Delay stomp boxes, for example, will prevent any strange distortionsto the time delayed repetitions.Please note that the EFFECTS LOOP sends at -10dB meaning it is suitable forstomp boxes.BYPASS ON/OFF: This is a true bypass effects loop which means if this is set in the“BYPASS” position, absolutely none of your original signal will be running throughuntil it’s switched “ON”.RETURN: Think of this as the “input” of the effects loop and will be connected tothe output of your effect(s).NOTE! Be sure to use shielded guitar cables only! NEVER use unshielded speakercables.SEND: Think of this as the “output” of the FX loop and will be connected to theinput of your effect(s).4. FOOT SWITCH jackThis is where you connect the Optional VFS2A Foot Switch so you can turn theREVERB and TREMOLO on and off.5. MAINS INPUT connectorThis is where the supplied, detachable Mains (power) cord is connected. Thespecific mains input voltage rating that your amplifier needs to run at is located onthe rear panel of your amplifier. Before making any connections or powering upthe amplifier, make sure the correct voltage is set. If you have any doubt, refer toyour local VOX dealer.11