AC30C2X/AC30C2/AC15C1 Owner's Manual - Vox

More documents

Recommendations

Info

REAR PANEL LAYOUTAC30C2(X)1 2 3(AC30C2(X) only) 4 51. POWER OUTPUT JacksThis is where you can hook up an extension or external speaker cabinet(s) ifdesired.EXTENSION SP: This speaker jack runs parallel with the internal speakers whichare wired for 16 Ohms. The extension cabinet must be 16 Ohms.EXTERNAL SP: This speaker jack will mute (disconnect) the internal speakers andyou can hook up either a 16 Ohm or 8 Ohm cabinet. Be sure to set the OutputSelect switch accordingly.NOTE! Hooking up a cabinet through the External jack will mute (disconnect) the internalspeakers!WARNING! To ensure that your system works correctly, you must observe the followingpoints.a) Don’t use an extension cabinet whose impedance is other than 16 ohms.b) Don’t connect a speaker whose rated input capacity is less than 30 watts (forAC30C2(X)) or 15 watts (AC15C1). The speaker may be destroyed if you ignorethis caution—not recommended!c) You must use a speaker cable to connect an external speaker. Don’t use ashielded cable like the one you use to connect a guitar to an amp.d) You must turn off the power before connecting the cable. Connecting the cablewhile the power is turned on may damage your amp.NOTE! It is recommended that all audio cables, with the exception of the speaker lead,used to connect to the AC30C2(X)/AC15C1 of a high quality, screened type.These should not exceed 10 metres in length. Always use a non-screened Voxapproved speaker lead with the AC30C2(X)/AC15C1 Amplifier and extensioncabinets.2. IMPEDANCE Select switch16 OHMS: Combos allow for the following configurations:1) Set it to this if you use the internal speakers only.2) Set it to this if you connect an external 16 Ohm speaker cabinet through theExternal jack.8 OHMS: Combos allow for the following configurations:1) Set it to this if you connect an extension cabinet through the Extension jack.You’ll be running the internal and external speakers in parallel. The impedance ofthe extension cabinet must be 16 Ohms.2) Set it to this if you connect an external 8 ohm speaker cabinet through theExternal jack.10
3. EFFECTS LOOP jack (AC30C2(X) only)The EFFECTS LOOP allows effects to be added further down the signal chain,rather than just plugging them in line with your guitar and amplifier. By using theEffects loop with Delay stomp boxes, for example, will prevent any strange distortionsto the time delayed repetitions.Please note that the EFFECTS LOOP sends at -10dB meaning it is suitable forstomp boxes.BYPASS ON/OFF: This is a true bypass effects loop which means if this is set in the“BYPASS” position, absolutely none of your original signal will be running throughuntil it’s switched “ON”.RETURN: Think of this as the “input” of the effects loop and will be connected tothe output of your effect(s).NOTE! Be sure to use shielded guitar cables only! NEVER use unshielded speakercables.SEND: Think of this as the “output” of the FX loop and will be connected to theinput of your effect(s).4. FOOT SWITCH jackThis is where you connect the Optional VFS2A Foot Switch so you can turn theREVERB and TREMOLO on and off.5. MAINS INPUT connectorThis is where the supplied, detachable Mains (power) cord is connected. Thespecific mains input voltage rating that your amplifier needs to run at is located onthe rear panel of your amplifier. Before making any connections or powering upthe amplifier, make sure the correct voltage is set. If you have any doubt, refer toyour local VOX dealer.11
Page 1: EFGS3
Page 4 and 5: IMPORTANT SAFETY INSTRUCTIONS• Re
Page 6 and 7: AC30C2(X) FRONT PANEL LAYOUT1 2 3 4
Page 8 and 9: AC15C1 FRONT PANEL LAYOUT1 2 3 4 5
Page 12: SPECIFICATIONAC30C2X• Dimensions
Page 15 and 16: INTRODUCTIONFélicitations pour vot
Page 17 and 18: 5. Commande TREBLEContrôle les hau
Page 19 and 20: AGENCEMENT DE LA FACE AVANT DE L'AC
Page 21 and 22: INPUTS (ENTRÉES)12. Prise TOP BOOS
Page 23 and 24: 3. EFFECTS LOOP (AC30C2(X) uniqueme
Page 26 and 27: WICHTIGE SICHERHEITSHINWEISE• Bit
Page 28 and 29: BEDIENFELD DES AC30C2(X)1 2 3 4 5 6
Page 30 and 31: POWER13. STANDBY-SchalterHiermit so
Page 32 and 33: flusst, was zu einem starken Zitter
Page 34 and 35: 3. EFFECTS LOOP-Buchse (nur auf dem
Page 36 and 37: INSTRUCCIONES DE SEGURIDAD IMPORTAN
Page 38 and 39: BEDIENFELD DES AC30C2(X)1 2 3 4 5 6
Page 40 and 41: PANEL FRONTAL DE AC15C11 2 3 4 5 6
Page 42 and 43: PANEL POSTERIORAC30C2(X)1 2 3(AC30C
Page 44: ESPECIFICACIONESAC30C2X• Dimensio

AC30C2X/AC30C2/AC15C1 Owner's Manual - Vox

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?